ACR Electronics 2985 Solución de problemas
Navegue en línea o descargue pdf Solución de problemas para Sistema de seguridad ACR Electronics 2985. ACR Electronics 2985 2 páginas.
También para ACR Electronics 2985: Pruebas (2 páginas)
Imprimir página
Troubleshooting
If you experience a false alarm whilst testing the system, it is likely because the connection between the Tag and the
Guardian was broken for longer than 3 seconds. If this occurs carry out the following steps to adjust your system.
1. Accept the alarm with the ACR OLAS App.
Alert Settings
3. Cancel the alarm on the Guardian by pressing the
(Guardian/Core)
control switch once. After 10 seconds the system will be
tracking again.
Siren (Default)
Pause Alert Sound
5. Adjust the Alert Delay to 4 seconds. This means if the
Connected to
connection between the Tag and the Guardian is broken
for longer than 4 seconds the alarm will sound.
(Guardian only)
Tom
Overboard!
Step 1
Press and hold the MOB button
on your GPS Chart Plotter
Step 2
Send a MOB DSC alert
using your VHF
Continue to recovery
10
Sound
Volume
Alert Delay
2
seconds
2. Bring the Tag within 1 meter of the Guardian.
s
0438
Near
4. Navigate to the Alert Settings in the ACR OLAS App.
6. Walk to the location where the Tag previously set off
the alarm and then continue walking around the vessel.
www.acrolas.com
Solo Mode
Vessel
0438
Near
Information
Alert Settings
Device Selection
FAQ's
Close OLAS
Firmware Update
Online
Tutorials
MOB
MOB
0438
Near
MOB
Alert Settings
Sound
Siren (Default)
Volume
Alert Delay
3
seconds
Pause Alert Sound
Connected to
(Guardian only)