ACR Electronics FPR-10 PROGRAMMER Manuel d'assistance produit - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'assistance produit pour {nom_de_la_catégorie} ACR Electronics FPR-10 PROGRAMMER. ACR Electronics FPR-10 PROGRAMMER 15 pages. Field programmer reader

Imprimer la page

7. If MMSI, Maritime Call sign, or Radio Call sign are chosen, you will be

prompted to enter the EPIRB number after entering the protocol and its value.

For example, if the EPIRB being programmed is the only one, press ENTER.

This will be coded as beacon 1 of 1. However, if there are 3 beacons on the

ship and you are programming the second beacon, enter a 2 in the box

provided. Click OK after entering the value.

8. The message will be generated and the program will return to the Option

Selection Menu. All of the information entered and used to make the message

can be seen at the top of the screen.

9. Make sure the FPR-10 interface unit is connected to the PC with the serial cable

and properly powered up (see Figure 5). Also, make sure the programming

head is connected to the interface unit.

10. On the Option Selection Menu there is a button on the bottom right corner for

changing the serial port to which the FPR-10 is connected. The default is

COM1, which is normally a 9-pin connection. If you have connected the FPR-

10 interface unit to a different serial port, be sure to change it by clicking the

button and entering the new value.

11. From the Option Selection Menu, click the Program New Hex ID Into Unit

button.

12. A box will appear with the message to be sent to the beacon and the

communications port it will use for programming. If all of this information is

correct, click OK, or click CANCEL.

13. Once the PC has sent the information to the FPR-10 interface unit, the green

LED on the programming head will turn on and stay on for approximately 15

seconds.

14. Make sure the programming head is properly located on the Satellite

beacon. See Figure 4 for positioning the programming head. The side of the

programming head with the LED should be directly over the LEDs on the

EPIRB.

15. Pull the test switch 1 time on the beacon.

16. There will be 2 short audible beeps from the EPIRB to indicate proper

programming. A message will also appear on the screen indicating the FPR-10

interface unit has sent the data through the programming head to the beacon.

To program an RLB-35, remove the connector from the front panel phone jack.

Note 4: An interlock prevents operation of the RLB-35 interface when the phone

jack is connected.

1. From the Product Selection Menu, click the GlobalFix 406 RLB-35.

2. Click the button of the model of the product you want to program, e.g. 2742 or

2744.

3. From the Option Selection Menu, Click the Generate New Hex ID button.

406

Y1-03-0164 Rev. A