ACR Electronics OLAS CORE Manuel
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} ACR Electronics OLAS CORE. ACR Electronics OLAS CORE 2 pages. Testing the alarm
Également pour ACR Electronics OLAS CORE : Manuel de démarrage rapide (12 pages), Test de précision (2 pages), Test de configuration et de portée (4 pages), Dépannage (2 pages), Test de configuration et de portée (4 pages)
Imprimer la page
Testing the alarm
FOR FIRMWARE VERSION 2.0+
1. Connect the ACR OLAS app to the Core. For more
information on how to do this please refer to the Core
Setup Instructions.
3. Switch o the ACR OLAS transmitters.
OLAS tag: press the button for 4 seconds, until a red flash is seen.
OLAS Float-On: press the button for 4 seconds until the bi-colour
turns red.
4. If testing with an ACR OLAS Tag or ACR OLAS
Float-ON the alarm will occur after your set 'Alert Time'
which has a default of 3 seconds. If testing with an ACR
OLAS T2 tag the alarm will occur immediately after it is
switched o .
MOB
Tom
Overboard!
Step 1
Press and hold the MOB button
on your GPS Chart Plotter
Step 2
Send a MOB DSC alert
using your VHF
Continue to recovery
www.acrolas.com
0438
Near
1152
Near
0347
Near
MOB
2. Ensure all ACR OLAS transmitters are seen on the ACR
OLAS app homescreen.
Solo Mode
Vessel
Information
0438
Near
Alert Settings
Device Selection
FAQ's
Close OLAS
Firmware Update
MOB
4. If using an ACR OLAS T2 go to 'Alert Settings' in the
menu and select the alert function for the ACR OLAS
T2. Now when you switch o your ACR OLAS T2 tag it
will activate the alarm immediately.
5. Press the control switch on the Core once. This puts the
system into pause.
ID: 0438
0347
Alert Settings
Sound
Siren (Default)
Volume
Detection Time
(seconds)
7
2
Alert Delay
0438
Far
(seconds)
4
2
Switch Active
(seconds)
5
5
Pause Alert Sound
OLAS T2 Function
Online
Tutorials
MOB
Tom
Overboard!
OR
Step 1
Press and hold the MOB button
on your GPS Chart Plotter
Step 2
Send a MOB DSC alert
using your VHF
Continue to recovery
15
30
60