Flisom eFlex 3x1 Manuel de sécurité et d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de sécurité et d'installation pour {nom_de_la_catégorie} Flisom eFlex 3x1. Flisom eFlex 3x1 16 pages.

Imprimer la page

Version: 01.12

Storage and Transportation

The eFlex modules with applied PV600BT adhesive should be stored in a shaded, dry and clean area

between 15°C - 25°C. When stored correctly the adhesive is usable up to 12 months. (see datasheet

HELIOBOND® PVA 600 BT in section 9.1)

Do not stand or step on the modules or their packaging. Do not accept modules delivered in damaged

packaging. Do not put pressure on the modules. Do not bend the modules to a radius of less than

500mm.

2.1

Packaging

The eFlex modules are packed in cardboard boxes. Box must not be stacked more than 3 Boxes high

Dimension (LxWxH)

Quantity of modules

Weight of a full box

modules without glue

Weight of a full box

modules with glue

Note: Other sizes to be confirmed.

Installation

Before installing modules, contact the appropriate authorities to obtain any required building permits

and to determine installation and inspection requirements that apply to the installation. Make sure that

unauthorised people have no access to the construction place. Do not install when it is raining,

snowing, windy or the ground is slippery. Flisom recommends to use personal protective equipment

such as safety gloves, safety googles and safety boots etc. Respect general safety rules.

3.1

Environment

Ambient temperature to install Flisom eFlex Series modules must be between 10°C and 50°C. They

can be operated in the range of -40°C to 85°C. Check if it is necessary to protect animals from the PV

system for example by installing cable guides or fences etc. Depending on the area it is necessary to

protect the modules from standing water, snow or extreme soiling. The described application solution

is limited to a snow and wind load (wind suction) of 2400 N/m

modules generate more power at lower temperatures. To improve the energy yield of the plant

increasing cooling or ventilation is an option (see thermal coefficients in the data sheet).

3.2

Handling

Flisom eFlex Series use thin polymeric sheets as backsheet. Hence they can bend by applying forces

while installation (e.g. dropping on the edges or corner). Please handle with care. Store modules in a

dry place. Do not transport modules without packaging. Do not put modules on top of each other to

avoid small scratches (this can accelerate module degradation by environmental factors). Do not use

Junction Box cables as handles to carry or lift the modules. Be cautious when frontsheet is wet since

the surface will be slippery. Do not apply solvents, adhesives, paint or stickers on the frontsheet. Do

not place the modules face-down in direct contact to abrasive surfaces. Do not bend a module over a

sharp edge.

This manual applies only on Flisom's eFlex Series modules

Safety & Installation Guide

Valid from 22.10.2018

eFlex 2x1

eFlex 3x1

80x40x47cm

10.4 kg

15.2 kg

7.2 kg

10.8 kg

eFlex 4x1

80x40x47cm

19.2 kg

14,0 kg

. At consistent solar radiation Flisom PV

FG2P1-4S1P00/1