Amcor AC12 Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Amcor AC12. Amcor AC12 13 pages. Portable air conditioner
Également pour Amcor AC12 : Manuel de l'utilisateur (12 pages)

Imprimer la page

WATER-DRAINAGE

MANUAL DRAINAGE

When the internal water tank is full the unit will stop working.

Shut off the unit and unplug. Avoid moving the model abruptly as

this may cause water to spill from the internal tank.

Place a tray under the water plug.

Unscrew

the Drain plug cap and remove the rubber stopper - water

will drain from the internal tank.

Put the rubber stopper back and screw the drain plug cap back into

place.

CONTINUOUS DRAINAGE:

Unscrew the drain plug cap and remove the rubber stopper. Fit the

drain connector within the cap

Connect a suitable pipe to the water outlet to remove the water out

continuously.

Note: This model is self-evaporative, which reduces the need to empty

the water tank.

If the unit is vented correctly most of the water is reused to cool the

condenser coils and any excess is evaporated.

Please do not use continuous drainage if you intend to use the self-

evaporate facility.

MAINTENANCE

CLEANING

Turn off the unit and unplug from the mains before cleaning or performing any maintenance.

CLEAN THE SURFACE

Clean the plastic housing with a duster or a soft wet cloth.

Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause

irreversible damage.

AIR FILTER CLEANING

Clean the air filters every 2 weeks. If the air filter is blocked with dust, the performance of

the unit will be significantly affected.

Pull out the top and bottom filters as pictured below

Wash the air filters by immersing them in warm (about 40℃) water with a neutral detergent.

Rinse it and then dry it thoroughly.

Carefully re-install air filters

END OF SEASON MAINTENANCE

1. Pull out the plug from the drainage hole and empty the internal tank. You should ensure

the tank is fully drained by leaning the unit backwards.

2. Then switch the unit to Fan mode,

3. Keep the unit in this mode for half day. Doing this helps to keep the inside of the unit dry

and prevents mold developing

4. Turn off the unit and unplug

5. Ensure the water tank is empty before replacing the rubber bung and drain cap.

6. Coil the wire and bind it together, then put it into the accessories space.

7. Separate the air-exhausted pipe and store it safely.

8. Cover the unit and keep it in a dry place.

9. Take the batteries out of remote control and store, or dispose, them safely

Drain plug cap

Rubber stopper

Drain connector

Drain plug cap

Drain pipe

(size: 10 mm)