Flocca Flow Manuel d'entretien rapide

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien rapide pour {nom_de_la_catégorie} Flocca Flow. Flocca Flow 2 pages. The ultrasonic meter measures the depth of flow entering the basin forebay through a defined size pipe or channel.

Imprimer la page

Flocca Flow - Quick Maintenance Guide

PERFORM WEEKLY OR PRIOR TO RAINFALL

1. SOLAR PANEL

Check solar panel faces north

Ensure no shadow on panel as this can significantly effect

the solar panel efficiency

Check cable attached on underside of Flocca unit

Wipe down glass panels to ensure free of dust

2. INSTALL OUTLET ASSEMBLY

Check IBC level is sufficient for next rainfall event

Top up or replace IBC if needed

Turn elbows down to allow IBC to drain when nearly empty

Replace flow meter or solenoid if these are more than 12 months

old or 6 months on high-use sites

3. CHECK ULTRASONIC SENSOR AND INLET

Check that ultrasonic is mounted securely in pipe / over channel

Tighten the nuts if needed

Check that ultrasonic cable is attached to correct socket

Make sure that pipe and channel are clear of any debris and sediment

4. TURN ON FLOCCA

Open external door with key

Check unit is switched on

5. CHECK MAIN SCREEN

Any recent flow and dosing data will be displayed in the statistics

Check if there is any dose pending (there could be a very small

negative amount, like -0.050, this is OK)

If there is an alarm showing, go to System Info – Alarms to clear by

unticking the box

The most common cause of an alarm is insufficient chemical in the

IBC, which causes the system to not register any flow through the

outlet. Refer to manual for further info on clearing alarms

flocca.com.au

Flocca Flow - Quick Maintenance Guide