Floe VSD 6000 Manuel d'instructions pour l'assemblage - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour l'assemblage pour {nom_de_la_catégorie} Floe VSD 6000. Floe VSD 6000 12 pages. Full length pontoon & tri-toon bunks large lifts
Également pour Floe VSD 6000 : Manuel d'instructions de montage (12 pages), Manuel d'instructions de montage (8 pages), Manuel d'instructions de montage (16 pages)
Imprimer la page
FOLLOW THESE GUIDELINES FOR USING AND LOCATING THE PONTOON BUNKS (FIGURE 2.5A & 2.5B).
-THE WIDTH OF THE BUNKS SHOULD BE 1-2 INCHES LESS THAN THE DISTANCE BETWEEN THE
PONTOONS.
-TO SET BUNK HEIGHT, MEASURE FROM THE BOTTOM OF THE PONTOON DECK TO THE BOTTOM OF
THE PONTOON, THEN ADD 1" TO THAT MEASUREMENT.
-THE REAR OF A 21 FOOT PONTOON BOAT SHOULD OVERHANG PAST THE LIFT BY 3 FEET. FOR EVERY
ADDITIONAL FOOT IN LENGTH OF THE BOAT, IT SHOULD OVERHANG BY AN ADDITIONAL 6 INCHES
BEYOND THE REAR OF THE LIFT.
THESE ARE THE GENERAL GUIDELINES THAT CAN BE ADJUSTED FOR AN INDIVIDUAL'S
CIRCUMSTANCES.
ONCE FINAL POSITION IS SET, TORQUE 3/8" NUTS ON CLAMPS TO 35 FT-LBS (FIGURE 2.6).
FIGURE
2.5A
UPRIGHTS MAY HAVE TO BE CUT TO
ALLOW FULL TRAVEL OF CRADLE ONCE
FINAL PLACEMENT IS ESTABLISHED.
NOTE:
SHEET 8 OF 12