Amcrest AF-2MBC-VARIW Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Amcrest AF-2MBC-VARIW. Amcrest AF-2MBC-VARIW 11 pages.

Installation

1) Locate the position in which you would like to place your camera and apply the included mounting sticker to the

surface.

2) Using a drill bit that is the same diameter or slightly smaller diameter than the included drywall wall anchors,

drill out the smaller circles on the sticker and insert the anchors into the holes.

Note: The wall anchors should be in the same bag as the screws and a designed to secure the screws onto the

mounting surface.

3) Attach the power and desired video cabling.

4) Thread the included screws through the base of the camera and into the wall anchors on the mounting surface.

Then, using a Phillips head screwdriver, secure the screws and base of the camera to the mounting surface.

Note: To adjust the camera, you can loosen the adjustment screws near the base of the camera. Adjust the

position as desired and tighten when complete.

This camera series will have three leads at the end of the wiring harness. Their functions are as follows:

Green: TVI,CVI,AHD

Yellow: Analog (CVBS)

Red: DC12V, 2.0A power input

Note: If the proper mode configuration is not set, you will not be able to view your camera on your DVR. Please

make sure you have the proper settings on your camera before you begin setting up or installing.

To connect your camera to your DVR, please follow the steps provided below:

Step 1: Connect a BNC (coaxial) cable to the video out connection of your camera.

Step 2: Connect the male end of the DC power connector of the BNC (coaxial) cable to the female end of the power

connector of the camera.

Step 3: Connect the BNC (coaxial) cable to a video out channel on the back of your DVR.

Step 4: Connect the male end of the DC power connector of the power adapter to the female end of the power

connector of the BNC (coaxial) cable. Plug in the power adapter to apply power to the camera.

For more information on the installation process described, refer to the image below for more details.