Flomec QS200 Manuel du propriétaire du produit - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire du produit pour {nom_de_la_catégorie} Flomec QS200. Flomec QS200 20 pages. Insertion ultrasonic flowmeter options for large pipe sizes
Également pour Flomec QS200 : Manuel d'installation (8 pages), Manuel du propriétaire du produit (16 pages)
Imprimer la page
UNPACKING
Contents:
920913-01 Quick Start Guide (QS200 Saddle)
(1) Saddle (sized specifically for your pipe O.D.)
(2) Band Clamps
(1) Retention Pin (Quick Release)
(1) Sensor Owners Manual
Inspect
•
•
To do a complete and successful installation, you must carefully read this manual
and the manual for the sensor.
BEFORE CUTTING A HOLE IN THE PIPE
•
•
•
•
•
•
•
Tools and Materials Needed
•
•
•
•
After unpacking the unit, inspect carefully for any damage that may
have occurred during transit. Check for loose, missing or damaged
parts. Shipping damage claims must be filed with carrier.
See General Safety Instructions, and all Cautions, Warnings, and
Dangers as shown.
Verify you have all the pieces.
Verify this saddle size is the same as your pipe outside diameter.
Verify the pipe is not pressurized.
Verify the desired hole location is more than 10 diameters downstream
and 5 diameters upstream from any obstructions. Valves, pumps,
elbows, reducers are all considered obstructions.
Note that the finished hole diameter should be between 1-15/16" to 2".
It should be clean and free of burrs.
We recommend the hole be made with a hole saw.
Note the direction of flow. Measuring water only.
Ø1-15/16" to Ø2.0" hole saw and drill
7/16" end wrenches
Tape measure
Permanent marker
4
(1) Sleeve
(1) Gasket
Hardware
(1) Sensor
(if ordered)