AMD VIA K8M800 Manuel de l'utilisateur - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AMD VIA K8M800. AMD VIA K8M800 13 pages. Chipset m/b for socket am2 64-bit dual core amd processor
Imprimer la page
(9) Secondary IDE Connector (40-pin block): IDE2
This connector connects to the next set of Master and Slave
hard disks. Follow the same procedure described for the
primary IDE connector. You may also configure two hard
disks to be both Masters using one ribbon cable on the
primary IDE connector and another ribbon cable on the
secondary IDE connector.
• Two hard disks can be connected to each connector. The
first HDD is referred to as the "Master" and the second HDD
is referred to as the "Slave".
• For performance issues, we strongly suggest you don't install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.
(10) Serial-ATA Port connector:
SATA1 / SATA2
This connector supports the provided Serial
ATA and Serial ATA IDE hard disk cable to
connect the motherboard and serial ATA hard
disk.
(11) Parallel Port Connector (25-pin female): PARALLEL1
The On-board Parallel Port can be disabled
SETUP. .
(12)
Serial COM Port: COM1
COM1 is the 9-pin connector. The On-board serial port can be disabled
(13) VGA Connector (15-pin D-Sub) Connector: VGA1
VGA is the 15-pin D-Subminiature female connector for display monitor.
3-2 Headers
(1) Line-Out/MIC Header for Front Panel (9-pin): AUDIO1
This header connect to Front Panel Line-out, MIC connector
with cable. Without install the cable, this header default
setting is 5-6 short, 9-10 short. When you install the cable
you have take off these jumpers.
SATA2
SATA1
Serial-ATA1 & 2 Compatible Connectors
by
the BIOS
9
IDE2
IDE1
Pin 1
Secondary IDE Connector
Pin 1
PARALLEL Connector
by
BIOS SETUP.
AUDIO
2
Pin 1
Line-Out, MIC Headers
10
9