AMD DIrect GWS-2314 Manuel d'installation et d'utilisation - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} AMD DIrect GWS-2314. AMD DIrect GWS-2314 6 pages. Glass windshields
Imprimer la pageINSTALLATION FOR RECTANGULAR/SQUARE WINDSHIELDS
Tools Needed: Phillips screwdriver, soft leather gloves for
handling glass, dry flat smooth surface large enough to
accommodate the windshield for assembly.
CAUTION: It is recommended for two people to assemble
the glass windshield. Lay the glass panels on a soft non-
abrasive flat surface to keep windshield level.
Note: Each GWS kit is designed for a specific type of
windshield. Ensure you read and understand how each kit
assembles and installs.
THE KITS LISTED IN FIGURES 1-3 ARE AVAILABLE TO
ORDER AS REPLACEMENT PARTS.
INDIVIDUAL PARTS ARE NOT AVAILABLE
SEPARATELY, YOU MUST ORDER THE ENTIRE KIT
(Qty. 4)
STRAIGHT
BRACKETS
(Qty.8)
Flat Screws
Fig. 1 GWS-STRAIGHT BRACKET KIT - Used with
rectangle and square windshields.
(Qty. 4)
Top
(Qty. 4)
Bottom
Fig. 2 GWS-CURVED BRACKET KIT - Used with round
windshields.
(Qty. 4)
Top
(Qty. 4)
Bottom
Fig. 3 GWS-BRACKET-S KIT - Used with rectangle and
square windshields.
Glass Windshields
(Qty. 4)
U-SHAPED
BRACKETS
(Qty.8)
Silicone Plugs
(Qty.16)
Flat Screws
(Qty.16)
Silicone Plugs
(Qty.16)
(Qty.16)
Flat Screws
Silicone Plugs
(Qty. 4)
(Qty. 4)
Screws
Feet
BEFORE YOU BEGIN
Each bracket uses a silicone plug on the opposite side of
the set-screw to secure the glass in place and to prevent
glass breakage. Loosen the set screws in all brackets to
allow glass to slip inside each bracket.
In most cases, assembly of the windshield will require more
than one person to assist. This is because the windshield
should be assembled upside down then inverted right side
up for installation around the fire pit.
WARNING:
Carefully secure the screws into position but do not
over-tighten. Warranty does not cover glass
breakage during the assembly process.
CAUTION: THESE WINDSHIELDS ARE NOT
DESIGNED FOR WOOD BURNING FIRE PITS.
POTENTIAL GLASS BREAKAGE AND DAMAGE WILL
OCCUR IF USED WITH A WOOD FIRE.
PREPARATION: Each kit requires partial assembly before
installing with the glass panels. You must press the
silicone plugs into the back of the flat screws, then thread
the screws partially into the brackets and install the screws
and feet into the bottom brackets to ready them to secure
the glass panels. See Figs. 4 and 5.
Press Silicone Plug
into Back of Screw
Fig. 4 Installing plug into flat screw.
Fig. 5 Installing feet to bottom brackets.
REV. D
Page 2