ACR STOVES Woodpecker WP5 PLUS Manuel technique - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel technique pour {nom_de_la_catégorie} ACR STOVES Woodpecker WP5 PLUS. ACR STOVES Woodpecker WP5 PLUS 18 pages.

Imprimer la page

User Instructions

Please read carefully to get the best from your ACR stove

Wood log fuel

(WP4/WP4LS/WP5/WP5Q-P/

WP5QLS/WP5 PLUS)

• Pull both air control levers fully

forward to allow maximum air for

lighting the stove

• Place two small wood logs onto the

grate leaving a small 20mm gap

between the logs

• Place 10-12 pieces of kindling on top

of the logs in a cross hatch method

• Place a non-paraffin based firelighter

on the top of the kindling

• Light the firelighter and push the door

to but do not engage the handle lock

fully

• Wait for the fuel load to fully ignite

(approximately 3 minutes) before fully

closing the door and engaging the

handle

• Once the fuel load has fully establish

(approximately 5 minutes) close the

primary air lever fully, the secondary

air control lever can be regulated

down to the desired comfort setting

WP4 Air Controls

Primary air

control

Secondary air

control

Smokeless Solid Fuel

(WP5/WP5Q-P/WP5Q-LS/WP5 PLUS)

If using Smokeless solid fuel (WP5/WP5

PLUS):

• Pull both air control levers fully forward

to allow maximum air for lighting the

stove

• Place 10-12 pieces of kindling on top of

the grate in a cross hatch method with 6-

10 smokeless briquettes on top of the

kindling

• Place a non-paraffin based firelighter on

the top of the kindling

• Light the firelighter and push the door to

but do not engage the handle lock fully

• Wait for the fuel load to fully ignite

(approximately 3 minutes) before fully

closing the door and engaging the

handle

• Once the fuel load has fully establish

(approximately 5 minutes) the air control

levers can be regulated down to the

desired comfort setting, the stove will

require primary air to allow the

smokeless fuel to combust fully

WP5/

WP5Q-P/WP5Q-LS/

WP5 PLUS

Air Controls

16 of 32

• Note - if the stove is fitted with a

smoke exempt stop it will prevent the

secondary air control lever from fully

closing.

• Care should be taken to ensure that

the logs are not placed where there is

a danger that they may fall onto the

glass or out of the chamber when the

door is opened.

• Never load logs into the appliance that

are oversized or too long for the

combustion chamber, they could press

against the glass and cause damage

when alight. The maximum log length

is 300mm or 400mm, depending on

the model.

Re-fuelling

When re-fuelling the stove always

refuel onto a bed of hot embers, fully

open the air control sliders until the new

fuel is well alight, before adjusting the

air control for the desired setting.

If there is insufficient burning material in

the firebed to light a new fuel charge,

excessive smoke emission can occur.

Refuelling must be carried out onto a

sufficient quantity of glowing embers

and ash that the new fuel charge will

ignite in a reasonable period. If there are

too few embers in the fire bed, add

suitable kindling to prevent excessive

smoke.

Fuel overloading

Never overload the stove - it will work

very well with two medium sized logs.

The amount of fuel specified in this

manual should not be exceeded,

overloading can cause excess smoke

and may cause products of combustion

to spill into the room.

• Never empty the ashes when the

stove is in operation, always wait until

the stove had burned out and cold.

• NEVER leave the ashes inside the

building, this can cause dangerous

levels of harmful Carbon Monoxide

to form in your home

• A helpful video on lighting your ACR

Woodpecker stove can be found on

our website "A guide to lighting your

ACR Stove":

https://acrheatproducts.com/video

• For more helpful information please

visit the frequently asked questions

section on our website:

https://acrheatproducts.com/faqs

Stove slumbering

The Woodpecker range of stoves has

been designed and tested as an

intermittent wood burning appliance.

Under no circumstances should this

appliance be operated as a slumber

style of stove or for continuous

overnight burning.

This may cause damage to the

appliance and cause excess smoke and

pollutants to enter the atmosphere.

Glass

Never operate the appliance if the glass

panel is broken or cracked. This can

cause the appliance to overfire, which

may damage the appliance and flue

system and may cause a danger to

persons and property. Only use once

the glass is replaced and the sealing

gaskets checked for integrity. Only

replace with a manufacturers approved

glass.

17 of 32