Amdi iAdapter Mini Instructions d'installation et d'utilisation

Parcourez en ligne ou téléchargez le pdf Instructions d'installation et d'utilisation pour {nom_de_la_catégorie} Amdi iAdapter Mini. Amdi iAdapter Mini 2 pages.

Imprimer la page

Installation and Operating Instructions for the iAdapter™Mini

Remove the screws to open the iAdapter™Mini

housing:

Remove the 8 (eight) screws from the back of the

iAdapter™Mini as shown in the picture below. Note

that the 4 (four) corner screws are longer than the

middle and side screws. The 4 (four) longer corners

screws MUST to be install back into the corners

when closing the iAdapter™Mini again.

Connect the stereo plug of the iAdapter™Mini:

Connect the stereo plug from the iAdapter™Mini

into the headset jack of the iPad®mini.

Align the reset button of the iAdapter™Mini:

Place the iPad®mini into the iAdapter™Mini and line

up the reset button of the iPad® with the reset

button of the iAdapter™Mini as shown in the picture

to the right.

Replace the screws to close the iAdapter™Mini

housing:

Place the top housing of the iAdapter™Mini over the

iPad®mini. Also align both top & bottom housings of

the iAdapter™Mini. Carefully hold both the top and

the bottom housing of the iAdapter™Mini together

and then turn it over onto a flat surface. Replace the

8 (eight) screws that will hold the iAdapter™

MAKE SURE THAT THE 4 (FOUR)

together.

LONGER SCREWS ARE USED TO SECURE THE 4

(FOUR) CORNERS.

**Longer screws in the corners**