10Bar 10BAR 450D Manuel de l'utilisateur - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} 10Bar 10BAR 450D. 10Bar 10BAR 450D 9 pages. Canon camera accessories user manual
Imprimer la page
4.7 Mounting the flashlight in the housing
Remove the lens cap and wrist strap. The pressure release plug should be pulled out before inserting the camera. Attach
the plastic slide tray to the camera¡s tripod mounting fixture with a coin, screwdriver or the end of the universal tool
supplied (Fig. 5). Take care not to excessively tighten the screw. Slide the camera into the body along the guide rail (Fig.
6). Make sure the camera body reach the limit and test the function of the on/of button on the body of the housing. Slide
the hot shoe plug into the hot shoe (Fig. 7) Note: If you find that the buttons do not align properly with the controls,
please check again that the camera is properly seated to the limit of the guide rail.
Replace the lid (Fig. 8). Remember to ensure the pressure release plug is pulled all the way out while closing, otherwise
the air cannot escape. Squeeze the lid closed all the way with the hissing of expelled air. Screw home (CLOCKWISE)
the pressure release plug (Fig. 9). There is no need to excessively tighten this plug. The seal is made by internal O-rings.
The O-ring on the underside of the plug is just to keep out dirt.
After replacing the lid, make a final visual inspection of the main O-ring for contamination (Fig. 10).
Note: If the O-ring is in good contact, a thin black line,
about 0.5-1mm in width should be visible, where the
O-ring is in contact with the lid. Follow this line all the
way round the edge of the seal, as a final check that the
seal is good. The housing is now ready for the dive.
Important !!!
Before diving, make sure the pressure
release plug is pushed back inside and then screwed
home, do not over tighten this plug (finger tight only).
6