10Bar 400D Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} 10Bar 400D. 10Bar 400D 11 pages. Canon digital camera 400d

Imprimer la page

4. Set up Instructions

4.1

Air Lock:

The body and lid are designed with the Air Lock System "no clip" closure arrangement. Testing

has shown that this arrangement allow the water to exert an even pressure on the O-ring, Increase the

reliability of the watertight seal.

4.2

Pressure release plug

To open the housing, the pressure release plug must be first unscrewed and then

pulled out all the way

and eliminate the pressure different between the inside of the housing and the ambient. The plug consists

of an internal double O-ring seal on the stainless steel slide shaft.

These internal O-rings form the watertight seal. There is also a large outer O -ring under the

knob. This O-ring serves to prevent contamination of the slide shaft, with dirt, salt etc., and is not required

for watertight integrity. If this O-ring should become detached, it can simply be pushed back in place.

(Fig. 1) Open Housing Procedure

4.3

Opening levers:

After unscrewing and pulling out the pressure release plug, the lid can be opened. To overcome

the friction of opening, use lever (Fig. 2) to push against the lid with a cam action. Be sure they are

inserted all the way flat to the housing before turning to avoid damaging the protrusions on the lid. The

body has four holes on each corner edges for opening. Gently lever off the lid with the supplied opening

lever (Fig. 3) taking care not to twist the lid excessively. The lid should be opened keeping it

approximately paralleled to the body at all times, turn first one corner a little, then the other a little, and

repeat again until the lid is opened. Remember to unscrew and pull out the pressure release plug all the

way first, otherwise the air pressure will resist attempts at opening. Lay the lid on a flat stable surface

after opening.

(Counter-clockwise)

(Fig 1). This provides a passage for the air to pass though