Coalesse SW 1 Instructions pour le service à la clientèle - Page 7
Parcourez en ligne ou téléchargez le pdf Instructions pour le service à la clientèle pour {nom_de_la_catégorie} Coalesse SW 1. Coalesse SW 1 7 pages. Replacement of knit and fabric components
Également pour Coalesse SW 1 : Manuel (11 pages)
Imprimer la page
Reassembly
NOTE: To ease reassembly and avoid damaging any components,
it is recommended that two persons be present when reassembling
this product.
1
.
To install tube frame assembly, align the two (2) holes on each
mounting plate in the frame with the mounting holes in the arm yoke.
Use an awl type tool to align holes and loosly install the screws. Prior
to tightening screws, adjust fabric evenly on the tube, then tighten all
four (4) screws. Make sure to secure the tube frame to the seat plate
with two (2) screws and branding badge and screws.
2
.
To install the shell, begin by engaging the the upper most mounting
slots in the shell onto the upper most mounting lugs in the tube frame.
Work the shell, side to side, and force it down to engage the lower
mounting lugs and slots. Check to ensure the shell is completely and
evenly seated onto the tube frame. Make any required adjustments to
ensure the fabric on the tube frame is evenly dispersed. Install two (2)
screws to secure the front of the shell to the tube frame.
3.
To install the seat cushion, begin by aligning the locating tabs at the
front of the cushion with the front of the seat plate. Rotate the cushion
back and engage the retaining tab with the slot near the back of the seat
plate. One installer must sit on the cushion to fully contact it with the seat
plate, while the second installer secures the cushion with four screws.
Ensure that the fabric on the tube frame is evenly dispersed.
MOUNTING
PLATE
ARM YOKE
BRANDING
SCREWS
BADGE
FRONT SHELL
1
SEAT PLATE
FRONT SCREWS
2
SCREWS
Chair seating shown. Lounge
seating procedure similar.
MOUNTING
SLOT
MOUNTING
LUG
LOCATING
SEAT PLATE
RETAINING TAB
3
NOTE: Sit in chair to fully contact
cushion to seat plate and disperse
frame fabric. Then install screws.
1070628001 Rev A
TAB
Page 7 of 7