Coastal Amusements MS0147 Manuel de l'utilisateur - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Coastal Amusements MS0147. Coastal Amusements MS0147 16 pages.

Imprimer la page

TROUBLE SHOOTING

Items

Description

Coin

No credit after coin in

Coins/tokens cannot

be inserted into coin

slot

Claw

Claw open after

Power

hitting upper-stop

switch

Claw is close after

power on

Claw doesn't close

Gantry Don't return to its

home position

Don't move either

forward and/or

backward by joystick

operation

Check and Maintenance

1. Check if the Coins vs. Plays is correct.

2. If Coins vs. Plays can't be adjusted, it's possible main board

problem. Please send the main board back for repair.

Comparative Coin Mech:

1. Check the sample coin at the coin mech.

2. Loose the coin mech sensitivity.

3. Check if DC12V input to coin mech.

4. Coin mech breakdown.

Multi-Coin Mech:

1. Adjust the coin mech data based on manual.

2. Check if DC12V input to coin mech.

VR2 is too low. Adjust VR2 higher according to objects

dimension and weight.

1. Claw coil burned.

2. Main board is out of service

1. Check if the CW at the fuse board burned?

2. Check if the black wire at claw coil connects well.

1. If power off and on again, the gantry still does not return to

its home position, then check if stop-back SW (Gantry &

Assembly I No. 23) or stop-left SW (Gantry & Assembly I

No. 21) are in proper position. Also check if their

connecting wires are properly connected.

2. Check if the air-plug of the gantry set connects well?

3. PCB is out of service.

1. Check if the forward/back motor fuse (FB) at the fuse board

is burned?

2. Check if J5 connecting pin of P.C.B. is properly connected.

3. Check if stop-front SW (Gantry & Assembly I No. 22) or

back-stop SW (Gantry & Assembly I No. 23) is in proper

position. Also check if their connecting wires are properly

connected.

4. Check if Front/Back motor is out of function or if its wires

are properly connected. Also check if its shaft pinion is

properly positioned.

5. Check if J9 connecting pin of P.C.B. is properly connected.

6. Check if all connecting pins of gantry are properly

connected to the machine.