Coastal Electronic UCONNECT LOCKPICK AIR V2 Manuel d'installation et d'utilisation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Coastal Electronic UCONNECT LOCKPICK AIR V2. Coastal Electronic UCONNECT LOCKPICK AIR V2 11 pages.

Imprimer la page

Lockpick provides an input on the module for a 2

extended view that you can enable or disable on demand using on screen menu options.

Connect your 2

installation diagram) and power the camera from the rear camera power provided on the

Lockpick harness.

If you want to add a front camera or left and right side cameras to your vehicle, the Lockpick is

prewired and programmed for exciting

labeled ADDITIONAL CAM POWER 12V+ to automatically provide the power needs of your

front and side cameras or to provide power and control of an interior baby camera if desired.

Connect the power needs of your additional cameras to the camera power output and attach

the GROUND connection of your camera to the GROUND connection provided for you on the

Lockpick harness. Connect the video from your cameras to the RCA video inputs labeled on

your Lockpick module. (see installation diagram)

The A/V inputs on your Lockpick module provide simple connection of your aftermarket DVD,

video game or other mobile multimedia source.

video inputs on your Lockpick module for full multimedia

10.

Also present on your Lockpick harness is a 12V ACC output connection.

created by the Lockpick and can be used as a convenient 12V switched power source for many

of your accessories. It is rated for a constant 1.5 AMPs and will automatically turn on and off at

the proper times of your vehicle use. If your power needs are greater than 1.5 Amps, you may

use the CONSTANT 12V output conveniently provided by the Lockpick harness and switch it on

and off through a relay powered by the ACC power output of the Lockpick harness.

**NOTE:

The connections for 12V Constant Battery power (YELLOW), ACC Ignition power (RED),

GROUND (BLACK), Reverse/2

(ORANGE W/STRIPE), are provided as a BONUS in your wiring harness for you to use when connecting

additional accessories such as a DVD player, Game, Cameras, Radar detector, etc., without worry that

they might drain your battery when the car is turned off. The ACC wire can power up to 1.5 Amps

constant. Higher loads should be connected with a relay.

** Do not attach the Constant or ACC wires directly to the vehicle wiring or ignition switch. The

Lockpick is plug and play for standard DVD/NAV/VIDEO/ /CAM unblocking and does not require

connections for power or ground. Connecting these Lockpick outputs to the vehicle wiring can damage

the unit and cause improper operations.

On Jeep Crysler vehicles equipped with an Uconnect 8.4 " with software updated to the MY2017

version, you can only manually activate the override from the Lockpick menu.

When using GPS navigation, the override function must be switched off.

rear camera to the video connection on the Lockpick module (see

REVERSE power(RED W/STRIPE), Front/Bab/Turn signal cam power

rear camera video input that allows an

options. The Lockpick harness has a 12V power output

Connect your device to the stereo Audio and

action.

This ACC output is