Coastal Electronic GMX550 LOCKPICK Manuel d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Coastal Electronic GMX550 LOCKPICK. Coastal Electronic GMX550 LOCKPICK 10 pages.

Imprimer la page

INSTALLATION DETAIL

Unplug the matching connectors on

the rear of the radio. Plug them into

the matching connectors of the

Lockpick harness. Then plug the

remaining Lockpick harness

connectors back into the original

radio locations. The connectors are

unique and keyed so you cannot plug

them into the wrong location. Insert

the connectors fully until they click

or are locked into place.

2. The GMX550 Lockpick is a simple Plug-N-Play interface however additional wiring is labeled and available on your

Lockpick harness. These connections may be used for your aftermarket accessory power needs.

RED – 12V ACC power output (Limit 1 amp) This is an output, do not connect to vehicle wiring. If your accessory

requires more than 1 amp, use this power output to control a relay connected directly to battery power.

YELLOW – 12V constant battery power output

BLACK – GROUND connection

ORANGE W/BLACK stripe – 12V rear camera power output (use this power source for your aftermarket rear

camera or for full control of your factory camera see step 3 below)

RED W/BLACK stripe – 12V ADDITIONAL camera power output (use this as the power source for front/left/right

view camera(s))

If you have a FACTORY REAR VIEW CAMERA

extend the ORANGE W/BLACK stripe 12V REVERSE wire labeled in your GMX550 harness. A crimp connector is

already attached for your convenience. Route the wire along the edge of the console and down to the small silver

module under the passenger seat. Slide the seat all the way back to view the connector on the front or side edge.

Unplug the connector and cut the Blue wire pictured in the photo below (end wire, left side, from the back of the

plug). Attach the ORANGE W/BLACK stripe GMX550 wire to the blue wire on the vehicle connector. The other cut

end of the wire in the factory harness should be insulated and left disconnected. Do not connect the Lockpick Orange

w/black stripe wire without cutting the BLUE factory wire or improper operation will occur. Also, early year Enclave

and Acadias may place the camera module in the rear instead of under the passenger seat. Refer to website at:

http://coastaletech/Acadia.htm

and run the GMX550 BLUE wire to the back of the vehicle and connect directly to the rear view camera connector

blue wire. Refer to website at:

OPTIONAL FACTORY CAMERA

LOCKPICK CONNECTION DETAIL

•

Unplug connector from module under

passenger seat.

•

Cut blue wire

•

Attach Lockpick Orange w/Black stripe

wire to blue wire of factory connector and

plug connector back into module

•

Crimp completed connection Cover

remaining loose end of blue wire left in

factory harness and leave disconnected

•

Anytime factory camera use is now enabled

by the GMX550

and would like to be able to view and control it when in DRIVE,

for installation help.

For 2008 and later H2 and all 2009-11 vehicle installations, extend

http://coastaletech.com/Hummer.htm

Unplug connector from camera module under passenger seat

and pull into view as shown. Cut and strip pictured blue wire as

demonstrated and attach to wire included with your Lockpick.

for example install pictures.