Aktacom ASE-1111 Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Aktacom ASE-1111. Aktacom ASE-1111 7 pages.

Cleaning and Maintenance

• For the best result and a long service life always keep the

soldering tip tinned.

• Regularly clean dirty soldering tips with a wet soldering

sponge.

• If the soldering tip has became passive and will not take to

the solder easily, take it out of the soldering iron.

Thoroughly clean it with 600 - 800 grid emery cloth. After

that the tip must be tinned again. Roll some solder with a

flux core around the tip and heat up the tip until the solder

has molten around the tip. Using additional colophony may

be helpful.

• If the tips are finally worn out, replace them to preserve the

full perform¬ance of the soldering station.

• Please pull the power plug before cleaning and allow it to

cool down fully!

• Avoid exerting excessive pressure on the LC display. Use

only a stiff brush and a moist cloth to clean the unit and

allow it to dry out before the next use.

• Do not use aggressive chemicals or abrasives to clean the

unit.

Visit

www.tmatlantic.com

for more information