Acer AL1717 Manuel de démarrage rapide - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Acer AL1717. Acer AL1717 2 pages. Diagonal 431.8mm (17 inch) lcd display
Également pour Acer AL1717 : Manuel de l'utilisateur (16 pages), Spécifications (2 pages), Manuel de l'utilisateur (10 pages), Manuel d'entretien (41 pages), Manuel de démarrage rapide (2 pages)
Imprimer la page
Installation
Note: Read the [Important] section carefully before starting the installation
Guide
Complete the following steps for quick installation: (See the figure)
Quick
Installation
Assemble the seat of the display
Connection to PC
Adjustment of Display
Key Definition
1
2
3
4
5
6
Take out the seat out of the box
table.
Take your LCD display out of the carton and assemble
the display and seat along the rail. You will hear a click
sound when the display and seat are engaged correctly.
Make sure that the power supply of your PC is turned off
and the power plug is removed.
Connect and fasten both ends of the signal cable to your
PC host and LCD display respectively.
If your LCD display has built-in speakers, connect the
audio cable attached to the display from the sound card
output of your PC to the audio input on the back of your
LCD display.
Connect the attached power cable to your LCD display.
Plug the power cable to the receptacle.
Turn on the power supplies of your PC and LCD display.
Power Source
Menu
OSD Menu
>
Plus
<
Minus
Auto
Automatic
Adjustment
Speaker
(For the model
with speakers)
and place it on a flat
Power On/Off
Green indication: Power is on and normal
Orange indication: Sleep status in the energy-saving mode
Colorless indication: Power off
Press this button to enter OSD. Press it again to exit OSD.
Press this button for selection or adjustment when OSD is
started.
Press this button and click < and > to adjust volume when
OSD is not started (for the model with speakers only)
Press this button to exit the manual when OSD is started.
Press this button for the display to optimize the position,
phase and clock pulse automatically when OSD is not
started.
Power Cable
Audio Cable
DVI Signal Cable (Optional)
D-Sub Signal Cable