Canon BJ M70 Manuel de référence - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel de référence pour {nom_de_la_catégorie} Canon BJ M70. Canon BJ M70 21 pages.

6. SPECIAL TOOLS

Clean spurs by using the spur cleaner in case spur marks are left on the print images.

Special tool (part number)

Spur cleaner (QY9-0055-000)

Usage

1) Moisten the fabric part of the spur cleaner with approx. 5 cc of water.

Moisten the fabric with the water, as shown below, so that the fabric absorbs the water

from end to end.

Be careful not to moisten the fabric with too much water. In case too much water is

used, there is the possibility that water will be wrung from the spur cleaner when

passing through the paper feed roller, spread inside the printer, and cause failure.

Be careful that the water

is absorbed by the

fabric from end to end.

Spur cleaner

2) Turn on the power of the printer. Remove the paper from the ASF to set the spur

cleaner with the fabric-affixed part of the cleaner face-up and to the top.

3) Press the RESUME button, and release it after the beeper sounds once. The spur

cleaner is fed and stops at the print start position.

4) Press the RESUME button again, and release it after the beeper sounds once. The spur

cleaner is delivered. Repeat procedures 3) to 4) approx. 5 times in case of heavy soiling.

5) Set a single sheet of paper to the ASF to repeat procedures 3) and 4). (To remove the

moisture remaining in the paper feeding path.)

Remarks

For cleaning spurs

Spur cleaner

Part moistened with water

Fabric (white-colored)

Transparent film

Fabric (white-colored)