Aktakom APS-7306 Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Aktakom APS-7306. Aktakom APS-7306 12 pages. Programmable dc power supply

Imprimer la page

OPERATION

Switching the Power Supply On or Off

1. Connect the included power cord to the back of the device [16] and

plug the other end into a suitable, earthed power socket.

Always connect the device to an earthed power socket.

Press the Power button [1] to switch the power supply on.

At this moment, there is no output voltage or current on the output

terminals.

Press the Power button [1] to switch the power supply off.

Using the Power Supply in Constant Voltage Mode

If you want to use the power supply in constant voltage mode, you set up the

desired output voltage between 0V and 30V. You also set up the desired

current limit.

If the output current exceeds the limit, the power supply automatically goes

into constant current mode.

Using the Power Supply in Constant Current Mode

If you want to use the power supply in constant current mode: you set up the

desired output current between 0A and 3A/5A. You also set up the desired

voltage limit.

Setting Voltage and Current

You can save 3 different voltage/current settings using the memory keys

M1~M3.

Press the Voltage/Current key [5] to set the voltage. The voltage readout

flashes.

o For use in constant voltage mode: this is the desired constant

voltage.

2. Turn the adjustment knob [11] until you reach approximately the

desired voltage. Press [11] to select a digit in the voltage readout [9] and

turn the adjustment knob to fine-tune.

3. Press the Voltage/Current key [5] again to set the current. The

current readout flashes.