aero-naut Marina Manuel de l'utilisateur - Page 17
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} aero-naut Marina. aero-naut Marina 20 pages.
Imprimer la page
45 Adjusting Outboard Motor
Install outboard motor to transom so that the centre of the
prop hub is on one level with the bottom of the hull.
The mounting screws should be located in the middle of
the slots on the motor mount, so that the height of the
outboard motor can be adjusted in either direction.
46
For additional tuning the tilt angle of the motor can be
adjusted. This will have an influence on the attitude of the
running boat on the water.
Loosen the lower screw of the pivot joint on the motor
mount and adjust the tilt angle. The top screw acts as a
pivot bearing.
Attention: Always loosen the connectors of the control
linkage on the servo arm before you adjust the tilt angle of
the outboard motor!
Pivot bearing
Loosen screw