aero-naut Princess Manuel d'instructions - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} aero-naut Princess. aero-naut Princess 17 pages. 3081/00
Imprimer la page
66
65
67
67
71
66
73
71
74
73
72
87
86
70
67
75
70
73
73
74
69
67
66
73
74
45
Glue the backrests 66 and 70 to the seats
65 and 69, followed by the uprights 67.
These are fitted under the seats; note that
the low end of the uprights should be
under the backrests.
46
Glue the backrest padding 71 and 75 to
parts 66 and 70, keeping the edges flush.
47
The seat covering 73 can now be stuck to
the padding 71: glue the upper part of the
covering 73 to the edge of the backrest 66,
secure it with adhesive tape, then glue the
side flaps of the covering 73 to the edges of
the backrest 66, again using adhesive tape
73
to secure them. Check that the edges fit
together neatly at the corners. If not, use a
small pair of scissors to make minor
adjustments.
48
Glue the padding 72 to the seat with the
edges flush. Glue the seat covering 74
centrally to the padding 72 and push the
flap projecting at the top between the seat
and the backrest. Pull the front edge down
and glue it to the seat. Repeat the
procedure with the side flaps. The bench
seat can now be padded and covered using
the same method.
49
Glue the covering 87 to the mattress
padding 86 and glue the projecting flaps to
the edges of the padding 86.