Aktobis AG WDH-E20 Manuel - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Aktobis AG WDH-E20. Aktobis AG WDH-E20 10 pages.
During the first operation:
As the heating elements are covered with a light film of oil at the factory for protection
reasons, you will notice a slight smell of burning and possibly some smoke when you first
use the appliance. This is quite normal at first and is caused by the oil film being burnt off
by the heating elements during operation.
Important safety instructions:
-
The heater is not suitable for outdoor use!
-
Please note that the heater can become very hot during operation, so always keep a
sufficient distance from flammable or highly flammable objects!
-
Do not place the heater directly next to a power socket!
-
Do not use a timer or automatic on/off switch in conjunction with this heater!
-
Never use the heater on moving surfaces, objects or vehicles! There is a risk of the
heater tipping over.
-
It is recommended to use a separate power source (socket) only for supplying the
heater. (Please do not use multiple sockets to operate the heater.) Furthermore,
please ensure that the power cable is always laid at a sufficient distance from the heat
source.
-
Supervise the heater when children are near the appliance!
-
Pay attention to the electricity, never go into the appliance with objects or insert them!
-
Do not place any objects on the heater!
-
Do not block the supply and/or exhaust air of the appliance and please ensure there is
sufficient space/clearance around the appliance!
-
Ensure that there is sufficient air supply to the appliance, otherwise this can lead to a
reduction in performance and, in the worst case, to overheating and/or fire!
-
Only qualified personnel or electricians are permitted to open the appliance!
-
Make sure that no water gets into or onto the appliance!
-
Ensure a minimum distance of 60 cm from bathtubs, showers or swimming pools!
-
Only use the recommended voltage for operating the appliance!
-
Make sure that the power cable is unfolded (untied) before you connect it to the
socket!
-
Make sure that the plug is clean and properly connected to the socket before using the
appliance!
-
Never touch the plug or socket with wet hands!
-
Do not repair defective or damaged cables on the appliance yourself, you could get a
serious electric shock!
Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
Email: [email protected]