Air & Allied Sales TOKU T-6 Maintenance Instruction
Parcourez en ligne ou téléchargez le pdf Maintenance Instruction pour {nom_de_la_catégorie} Air & Allied Sales TOKU T-6. Air & Allied Sales TOKU T-6 4 pages. Air tamper
MAINTENANCE INSTRUCTIONS
AIR TAMPER
MODEL
AIR HOSE AND HOSE CONNECTION
OPERATING INSTRUCTIONS
WARNING
Safety is a primary consideration when operating percussion tools. The following information outlines procedures which
should be following to help insure a safe working environment to avoid personal injury.
1. ALWAYS WEAR APPROVED IMPACT RESISTANT EYE PROTECTION.
2. ALWAYS WEAR EAR PROTECTION.
3. ALWAYS WEAR GLOVES AND OTHER PROTECTIVE CLOTHING.
4. ALWAYS DIRECT EXHAUST AWAY FROM YOURSELF AND OTHERS IN THE AREA.
5. ALWAYS DISCONNECT TOOL FROM THE AIR SUPPLY WHEN NOT IN OPERATION. IF QUICK-DISCONNECT
COUPLINGS ARE USED, SEPARATE THE COUPLING FROM THE TOOL WITH A LEADER HOSE.
LUBRICATION
To flush out GUM and dart – you should do the following
two steps EACH DAY.
1. (Before the shift), pour a liberal quantity of gum solvent
oil into the tool's air inlet.
2. Connect tool to air line and operate.
Repeat this procedure before storing the tool.
Air line lubricator should be used in conjunction with the
integral oiler.
The important of adequate and continuous lubrication
cannot be overemphasized.
A few minutes operation without oil may severely damage
the valve parts, cylinder and piston.
AIR SUPPLY (minimum requirements)
1. Compressor / 10hp, 40CFM at 90psig (6.2bar).
2. When using two or more tools, all except leader hoses
should be 1" or larger. (see diagram above for piping and
fittings.)
FOR BEST OPERATION :Supply tool with 90psig (6.2bar)
of clean, dry air.
Higher pressure drastically tool life and can void warranty.
SPECIFICATIONS
Piston
Type
Dia.
No.
(mm)
(in)
T-6
38.1
1-1/2
T-6
Number
Piston
of
Stroke
Impacts
(mm)
(in)
(bpm)
140
5-1/2
600
Air & Allied Sales (Pacific) Pty Ltd
LOSS OF POWER / ERRATIC ACTION (possible causes)
1. Reduce compressor output.
2. Excessive drain on air line.
3. Moisture or restricted pipes, hoses or fittings.
4.
Improper size or poor condition of pipes, hoses or fittings.
5. Free running (or blank blow) can cause damage to the
tool. Always hold the tool down to the work.
If everything else appears to be in order, then disassemble
tool, replace worn or damaged parts, clean, reassemble and
lubricate.
REPLACEMENT PARTS
Always use GENUINE TOKU TOOLS Replacement Parts.
When replacement parts are required, order by Parts
Number and Description from the Parts List.
PRESS THE TAMPER WITH PROPER PRESSING FORCE
Press the Tamper with proper pressing force.
Excess pressing force become less working efficiency or
stop working. Maximum pressing force is up to 15kgf (33lb)
Net
Overall
Weight
Length
(kg)
(lb)
(mm)
(in)
16.7
36.7
1,240
48-7/8
1
www.air-allied.com.au
Air
Hose
Consumption
Size
3
(CFM)
(mm)
(m
/min)
1.10
38.5
12.7
www.air-allied.com.au
3rd edition
(in)
1/2