BOBPERRY AUDIO Ducker Pro 2 Manuel - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} BOBPERRY AUDIO Ducker Pro 2. BOBPERRY AUDIO Ducker Pro 2 18 pages.

Display SPEC Mode

Click SPEC to enable SPEC mode. In this mode, the Display shows the Spectrogram Display,

which always displays the Aux signal.

When either LO CUT or HI CUT filter is set, the corresponding filter curves are shown.

●

Red: Low Cut Filter,

You can use your mouse or trackpad to move the filter curves right on the display:

Use Area A to change the LO CUT value

•

Use Area B to change the HI CUT value

•

Use Area C to change both LO CUT and HI CUT values

•

You can also:

Double-click Area A or Area B to disable the corresponding filter

•

Double-click Area C to synchronize LO CUT and HI CUT frequencies.

•

Use your mouse wheel on any area to change the FILTER RESONANCE. See below

•

for details.

Area C does not exist when the filter frequencies are too far apart.

Display AUTO Mode

Click AUTO to enable AUTO mode. In this mode, the Display automatically switches between

WAVE and SPEC modes, defaulting to WAVE mode.

SPEC mode will be enabled whenever FILTER LISTEN is on.

With AUTO FILTER LISTEN enabled, the Display will also be in SPEC mode when using the

LO CUT or HI CUT dials.

The filter curves are not mouse-draggable in AUTO mode.

VST is a software and trademark of Steinberg Media Technologies GmbH.

●

Orange: High Cut Filter.

Bob Perry Ducker Pro 2 – Manual – Page 6/18

20210113160816