Euro-Pro Shark EP750H Manuel du propriétaire - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Euro-Pro Shark EP750H. Euro-Pro Shark EP750H 14 pages. 2-in-1 hand & floor vac with super size motorized floor brush
Imprimer la page
Battery Pack Replacement & Disposal
This vacuum cleaner contains a nickel-cadmium (Ni-Cd) batteries. Batteries must be
recycled or disposed of properly. Call your nearest recycling center for information
on the recycling and disposal of nickel-cadmium (Ni-Cd) batteries.
If uncertain as to how to remove the battery pack, we suggest you take your hand
vacuum to a reputable small appliance service technician to have this service
preformed.
The battery pack of your EP750H is replaceable, however care should be taken
when doing so. Follow these steps when replacement is required:
1. Remove unit from charging stand and /or remove the charging adapter jack,
before changing batteries. Ensure that the "On / Off" switch is in the "Off"
position.
2. Open the battery pack compartment by removing the single Phillips head screw
located in the recess at the rear of the unit. NEVER open the battery
compartment except to change the battery pack when required.
3. Remove battery compartment cover. Set aside battery compartment cover with
the screw.
4. Carefully detach the two (2) electrical connectors from the battery pack by pulling
straight out from the battery pack.
5. Lift out the battery pack and set aside.
6. Insert the new battery pack and re-connect the terminals by pushing lead wires
onto battery tabs.
7. Tuck the wiring inside the battery compartment so that the wiring does not
interfere with the battery compartment cover when it is replaced.
8. Re-install the battery compartment cover by sliding it over the battery towards the
front of the unit, making sure that the front snap engages the body of the unit.
9. Replace the battery compartment cover screw.
WARNING
:
NEVER use ordinary
batteries for replacement, as these may
leak and damage your vacuum cleaner.
Use only battery pack XB75018
provided by EURO-PRO Operating LLC
for replacement.
CAUTION
: NEVER use the unit
without the battery compartment cover
in place.
NOTE: Any other servicing should be
performed by an authorized service
representative.
CAUTION
•
Use only with the battery pack
supplied with the unit.
• Do not attempt to remove the battery
pack from the unit to charge it.
• Never attempt to throw the battery
pack or unit into a fire or incinerate it.
• Do not attempt to remove or damage
the battery casing.
• Battery must be recycled or disposed
of properly at the end of it's
service life.
6
ASSEMBLAGE
Remarque : Le filtre Type-HEPA doit être utilisé avec l'aspirateur portatif.
1. Pour ouvrir la coupelle à poussière (Fig. 1), appuyez sur le bouton et détachez-la.
(Fig. 2) Vérifiez que le filtre Type-HEPA est à l'intérieur et rattachez la coupelle sur
l'aspirateur portatif.
Figure 1
2. Pour attacher la brosse convertible ou le suceur plat à l'aspirateur portatif, poussez
l'accessoire dans la trappe de succion. (Fig. 3)
3. Afin d'utiliser l'électrobrosse, branchez la fiche du cordon en spirale de la brosse à
la prise sous l'appareil. Mettez l'appareil en marche. (Fig. 4, 5) Le cordon en
spirale se trouve dans le compartiment de rangement de l'électrobrosse. (Fig. 6)
Figure 4
4. Afin d'utiliser les tubes de rallonge, poussez le tube doté du joint de caoutchouc
dans la trappe de succion de la coupelle à poussière. Insérez ensuite l'autre tube
de rallonge dans le premier. Insérez la brosse motorisée dans le deuxième tube de
rallonge. Faites fonctionner l'électrobrosse tel que décrit au no. 3. La brosse
convertible et le suceur plat peuvent aussi être utilisés avec les tubes de rallonge.
(Fig. 7)
Insérez le tube de rallonge avec le joint
dans la trappe de succion de la coupelle
Figure 2
Figure 3
Figure 5
Figure 6
Figure 7
19