BOCCHI LEVANZO 1602 0126 Series Manuel d'instructions d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} BOCCHI LEVANZO 1602 0126 Series. BOCCHI LEVANZO 1602 0126 Series 20 pages. Granite kitchen sinks

Imprimer la page
Undermount Installation:
•
BOCCHI recommends a "Flush" installation for models 1602, 1604, 1606, 1608, and 1634. "Negative"
and "Positive" installations are possible if preferred; however it is important to consider the faucet hole
placement when choosing your installation method as the hole is in a fixed position on the sink.
•
BOCCHI recommends a "Positive" installation for models 1616, 1618, and 1635. The 1616 and 1618 sinks
should leave the workstation ledge exposed to allow for use with accessories.
COUNTERTOP
SINK
Flush Installation
•
Cut the template provided with the sink at your selected sink and installation option (undermount versus
drop-in) and place the template on the counter in the location you will install the sink. Make sure there is
enough clearance for the faucet and backsplash.
•
With the template in the correct spot for installation, use painter's tape to secure it to the countertop.
•
Trace the outline of the template with your pen or pencil.
•
Remove the template from the countertop leaving the marked spot for the sink.
•
Add painter's tape around the outside edge of the marked line for protection of the countertop before
starting your cut.
•
Using the power drill, drill a starting hole for the saw in the area of the countertop to be cut out.
•
Carefully cut out the needed section, using the proper type of saw for your countertops.
•
Turn over the countertop and place the sink over the cut out.
•
Trace the outside of the sink with a pencil or marker.
•
Mark the location of the mounting brackets and remove the sink. NOTE: the underside of the sink has a
marked spot of each of the mounting brackets. It is important to use all brackets provided your sink.
•
1/4 inch from the sink side, use a 3/8 inch drill bit to drill a 3/8 inch diameter hole to a 3/8 inch depth using
a depth stop.
•
Tap the anchors in to the holes using a hammer (glue is not needed).
4
COUNTERTOP
1/8"
SINK
Negative Installation
COUNTERTOP
SINK
Positive Installation
continued on next page
www.BOCCHIUSA.com
1/4"