American Standard 2071S Instructions d'installation - Page 3
Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} American Standard 2071S. American Standard 2071S 4 pages. American standard monoblock lavatory faucet with cross handle
Imprimer la page
4
TEST INSTALLED FAUCET
AND CHECK FOR LEAKS
With HANDLE (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3).
Operate HANDLE (1) to flush water lines thoroughly.
Replace AERATOR (3).
4a
CHECK DRAIN CONNECTIONS
Operate LIFT ROD (4) and fill lavatory with water. Check that
DRAIN STOPPER (5) makes a good seal and retains water in
lavatory. If necessary adjust stopper height by repositioning
LIFT ROD (4) and tightening Thumbscrew (6).
Release DRAIN STOPPER (5) and check all drain connections
and "P" trap for leaks.
5
ADJUST HOT LIMIT STOP
By restricting HANDLE rotation and limiting the amount of hot water
allowed to mix with the cold, the HOT LIMIT SAFETY STOP (5) reduces
risk of accidental scalding. To set the maximum hot water temperature
of your faucet, all you need to do is adjust the setting on the HOT LIMIT
SAFETY STOP (5).
Remove INDEX BUTTON (1), HANDLE SCREW (2) and pull off HANDLE (3).
Turn CARTRIDGE STEM (4) to the OFF position (coldest setting) before
making adjustment to HOT LIMIT STOP (5). Use a flat blade screwdriver
to pry free the HOT LIMIT SAFETY STOP (5). Pull upward and rotate
counterclockwise one number to limit hot water temperature. Use
ARROW (6) on CARTRIDGE (7) and NUMBERS (8) on HOT LIMIT STOP (5)
for indication.
Replace HANDLE (3), HANDLE SCREW (2) and INDEX BUTTON (1).
4
M 9 6 8 2 9 0 A
Tighten if necessary.
6
8
5
FLAT BLADE
7
SCREWDRIVER
4
HOT
1
HOTTER
(Smaller Numbers)
0 1 3 5 7 9 11 13 15
5
4
6
1
3
6
5
"P" TRAP
COLD
2
1
2
3
5
COLDER
(Larger Numbers)
0 1 3 5 7 9 11 13 15
5