Domus 25011 Manuel d'installation
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Domus 25011. Domus 25011 4 pages.
Imprimer la pageMURO-26S
Order Code
Product Code
25010
MURO-26S-B-W
25011
MURO-26S-S-W
25012
MURO-26S-W-W
Thank you for purchasing your new LED MURO-26S, Please take the time to read and understand the instruction
sheet below. Failure to do so may void warranty.
Introduction
The Security Light incorporates a PIR (Passive Infra Red) sensing device which continuously scans a preset
operating zone and immediately switches the light on when it detects movement in that area.
This means that whenever movement is detected within the range of the sensor, the light will switch on
automatically to illuminate pathways, steps, patios, porches, or whatever area you have selected to light for
reasons of safety, convenience or security.
While there is movement within range of the unit the light will remain on.
Fitting your security lamp
• Ideally the security lamp should be mounted 1.8 to 2.5 metres
(6 to 8ft) above the ground to be scanned.
• To avoid damage to unit - do not aim the sensor towards the sun.
• To avoid nuisance triggering, the sensor should be directed
away from heat sources such as barbecues, Air-conditioners,
other outside lighting, moving cars and flue vents.
• To avoid nuisance triggering, keeping away from the area of
strong electromagnetic disturbance.
Detection Area Setup
Do not aim towards reflective surfaces such as smooth white walls,
swimming pools, etc. The security lamp scanning specifications
(approximately 12 metres at 180°) may vary slightly depending on the
mounting height and location. The detection range of the unit may also
alter with temperature change. Before selecting a place to install your
security lamp you should note that movement across the scan area is
more effective than movement directly toward or away from the sensor.
If movement is made walking directly towards or away from the sensor
and not across, the apparent detection range will be substantially
reduced.
Note:
-The lamp must be installed by professional electrician
-Ensure the power supply is switched off before fitting this product
29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
Phone: 02 9554 9600
Description
2 x 13W Double Spot with Sensor Black / White LED 5000K
2 x 13W Double Spot with Sensor Silver / White LED 5000K
2 x 13W Double Spot with Sensor White / White LED 5000K
-Do not touch the lamp when in use
-Keep away from hot steam and corrosive gas
|
|
www.domuslighting.com
Installation Manual
4M
Detection Area
Good
Fax: 02 9554 9433
appro.180°
8M
12M
Not Good