Domus MURO-PRO-15S-WHT-TRIO Manuel d'installation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Domus MURO-PRO-15S-WHT-TRIO. Domus MURO-PRO-15S-WHT-TRIO 4 pages. 15w spotlight with sensor, black finish (trio)

Imprimer la page

How to change into MANUAL OVERRIDE CONTROL MODE

1. Switch Main Power ON, the PIR Sensor will enter a WARM-UP Period. After 1 minute, it automatically changes into AUTO mode

(leave Main switch ON and wait for lamp to switch itself OFF automatically).

2. Once the lamp is OFF, change the Main switch from the ON position to the OFF position (3) times within 3 seconds. This will

change the sensor into MANUAL mode, in this mode the lamp will remain ON all the time.

3. To revert back to AUTO mode just switch the Lamp OFF, wait 8 seconds and switch it back ON.

Trouble shooting and user hints

Problem

Light does not switch on

when there is movement in

the detection area.

Lamp switches on for no

apparent reason (false

trigger)

Light remains on.

Light switches on during

daylight hours.

When setting controls

in daylight the detection

distance becomes shorter.

Note: all passive infra red detectors are more sensitive in cold and dry weather than warm and wet weather

Note:

-The lamp must be installed by professional electrician

-Ensure the power supply is switched off before fitting this product

POWER ON

Possible Cause

1. No mains voltage

2. Bulb(s) faulty or missing.

3. Nearby lighting is too bright.

4. Controls set incorrectly

5. Sensor positioned in wrong direction

1. Heat from bulb(s) activating sensor.

2. Heat sources such as air-con, vents, heater flues,

barbecues, other outside lighting, moving cars are

activating sensor.

3. Animals/birds e.G. Possums or domestic animals.

4. Interference from on/off switching of electric fans

or lights on the same circuit as your security floodlight.

(This problem does not always occur but a faulty

switch or noisy fluorescent light may cause the security

lamp to switch on.)

5.Reflection from swimming pool, or reflective surface. Redirect sensor.

1.Continuously false triggered

2. Time is set too long.

LUX control knob is set to daylight position.

interference by sunlight

29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia

Phone: 02 9554 9600 | Fax: 02 9554 9433

[email protected] | www.domuslighting.com

AUTO MODE

MANUAL MODE

Suggested Remedy

Check all connections, and Fuses/switches

Check. Replace

Redirect sensor or relocate the unit

Readjust sensor angle or control knob

Redirect sensor and/or adjust

Adjust lamp holders to allow a Minimum gap of

40mm between LED bulb and sensor head.

Adjust direction of sensor head, Away from these

sources.

Redirecting sensor head may help.

Should the false triggering become troublesome,

consider:

a) Replacing a faulty switch. b) Replacing noisy

fluorescent, Tubes and/or starters. c) Connecting

the security lamp to a separate circuit(in most cases

where one or more of the above suggestions have been

carried out, false triggering has been reduced.)

Redirecting sensor head may help

Reduce time

Turn the LUX control knob to desired light level setting.

Re-test at night.

-Do not touch the lamp when in use

-Keep away from hot steam and corrosive gas

Installation Manual