American Standard Metering 1340.225 Instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} American Standard Metering 1340.225. American Standard Metering 1340.225 3 pages. American standard center set faucets installation instructions

Imprimer la page
TEST INSTALLED FITTING
Turn on water supplies and check connections for leaks.
Remove AERATOR (1) with KEY (2) supplied.
Operate HOT and COLD HANDLES by pressing down on
HANDLES. Both Hot and Cold handles are set for approximately
8 second operating cycles.
Replace AERATOR (1).
WATER SUPPLIES
"
TO ADJUST CYCLE TIME
Remove HANDLE (1) by removing INDEX BUTTON (2)
and SET SCREW (3) with a 2.5mm hex wrench.
Pull off HANDLE (1).
To increase cycle time, turn the gray PLASTIC ADJUSTING
NUT (4) clockwise.
To decrease cycle time, turn the gray PLASTIC
ADJUSTING NUT (4) counter-clockwise.
Replace SET SCREW (3), INDEX BUTTON (2) and
HANDLE (1). Test faucet for proper operation and
cycle time.
3
2
2.5mm HEX WRENCH
TO DECREASE CYCLE TIME
ROTATE COUNTER-CLOCKWISE
4
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR
WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH,
ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A
COARSE SURFACE.
PRESS HANDLE
DOWN TO
OPERATE
1
2
1
TO INCREASE CYCLE TIME
ROTATE CLOCKWISE
#
SERVICE
Remove HANDLE (1). Refer to Step 4 for handle removal.
Remove ACTUATOR ASSEMBLY (2).
Remove WASHER (3). Pull out VALVE ASSEMBLY (4) and
FILTER SCREEN (5).
Inspect that VALVE ASSEMBLY (4), FILTER SCREEN (5) and
VALVE SEAT (6) are clean and free from debris. VALVE
ASSEMBLY (3) and FILTER SCREEN (5) can be cleaned with
soap and water.
Replace FILTER SCREEN (5) and VALVE ASSEMBLY (4). Place
WASHER (3) on top of VALVE ASSEMBLY (4). Thread VALVE
ACTUATOR (2) onto faucet. Torque VALVE ACTUATOR (2)
to 12-15 ft. lbs (15-20 Nm).
Replace HANDLE (1).
REMOVE
4
5
$
CONVERT RIGID SPOUT TO SWIVEL SPOUT
(1340.255; 1340.265)
Unthread SPOUT NUT (1) and remove SPOUT (2)
Remove SPOUT CLIP (3) and O-RINGS (4).
Replace RUBBER RING (5) with separate
PLASTIC RING (6) supplied with faucet.
Replace SPOUT CLIP (3) and O-RINGS (4).
Reassemble SPOUT (2) TO BODY.
1
5
REMOVE
RUBBER RING
3
6
INSTALL
PLASTIC RING
1
REPLACE
2
3
2
4
968493