Baroness LM2700 Informations techniques - Page 4

Parcourez en ligne ou téléchargez le pdf Informations techniques pour {nom_de_la_catégorie} Baroness LM2700. Baroness LM2700 6 pages. Backlapping
Également pour Baroness LM2700 : Informations techniques (5 pages)

Imprimer la page

Turn the cutting reels on by pressing this

switch forward.

Select the cross-cut position of the cutting

units by pressing this switch forward.

Lower the units to the floor by pushing this

leaver forwards. Please note that the

cutting cylinders should not be rotating as

these were turned off at the motors earlier

in the process.

Your assistant should remain on the seat throughout the process and should be fully briefed and

familiar with the emergency shut-down procedure.

With the aid of an assistant and with the

parking brake on, start the engine and

leave it running at idle. The assistant

should remain on the seat and able to

stop the machine in an emergency.

With the engine running select cutting

cylinder reverse (switch back). Please

note that on newer models you will find

this switch located under the engine

cover on the right hand side just below

the relays.

Select the first cutting unit that you

want to back-lap and turn the unit on

using the hydraulic motor selection

lever as shown.

The cutting cylinder should now start

rotating in a reverse direction.

Note: Do not perform the back-

lapping process with the cylinders

rotating in the normal cutting

direction.