American Standard 1713 Monarch Series Manuel d'installation et d'utilisation - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} American Standard 1713 Monarch Series. American Standard 1713 Monarch Series 16 pages. Aths with integral apron
Également pour American Standard 1713 Monarch Series : Manuel d'installation et d'utilisation (6 pages)
Imprimer la page
ALWAYS SWITCH OFF POWER BEFORE SERVICING.
THE ELECTRONIC CONTROL FAILS TO OPERATE:
1. VERIFY ELECTRIC POWER SUPPLY. RESET
CIRCUIT OR REPLACE FUSE IF NECESSARY.
2. VERIFY ALL ELECTRICAL CONNECTIONS
(INCLUDING KEYPAD CONNECTION).
3. VERIFY THAT THE GROUND FAULT CIRCUIT INTER-
RUPTER (G.F.C. I.) HAS NOT TRIPPED.
4. IF THE SYSTEM HAS BEEN FUNCTIONING FOR
QUITE SOME TIME, IT IS POSSIBLE THAT THE
THERMAL PROTECTION HAS SHUT OFF THE
MOTOR. IT IS INDICATED TO SWITCH OFF THE
SYSTEM AND TO WAIT FOR AT LEAST 30 MINUTES
BEFORE USING IT AGAIN. VERITY THAT AIR IS
FLOWING THROUGH ALL JETS. IF NOT; COVER THE
JETS WITH WARM WATER, THEN SWITCH SYSTEM
Functions
• PRESS THIS KEY TO START OR STOP THE BLOWER.
• PRESS AND HOLD THIS KEY TO INCREASE OR DECREASE THE BLOWER SPEED UNTIL
DESIRED LEVEL
• 1ST PRESS - SPEED WILL VARY GRADUALLY FROM MAXIMUM TO MINIMUM AND BACK TO
MAXIMUM.
• 2ND PRESS - SYSTEM TURNS OFF AND ON, ALTERNATELY.
• 3RD PRESS - RETURNS TO MAXIMUM SPEED.
THE SYSTEM WILL STOP AUTOMATICALLY AFTER 20 MINUTES.
ADVANCED FUNCTION:
AN AUTOMATIC DRYING CYCLE WILL START 20 MINUTES OTTER THE BLOWER IS TURNED OFF.
OPTIONAL, WATER LEVEL DETECTORS:
IT ACTIVATES A DRYING CYCLE 20 MINUTES AFTER THE BATHTUB IS EMPTIED EVEN WHEN THE SYSTEM WAS
NOT USED.
757222-A
Troubleshooting - Air System
BLOWER MODE
ON AND OFF SEVERAL TIMES. THE AIR OUTLETS
SHOULD BE CLEARED. IF THIS IS NOT SUFFICIENT.
CAREFULLY KNOCK ON THE JET HEADS WITH THE
HANDLE OF A SCREW DRIVER OR A SIMILAR
PLASTIC TOOL WHILE THE BLOWER IS RUNNING.
5. IF YOU HAVE ADDED A KEYPAD EXTENSION, MAKE
SURE THAT IT HAS BEEN CERTIFIED BY THE
MANUFACTURER OF THE ELECTRONIC CONTROL.
IT COULD BE THE CAUSE OF YOUR PROBLEM.
THE BLOWER OR PUMP NEVER STOPS:
1. VERIFY THAT THE BLOWER IS WELL CONNECTED
TO THE CONTROL BOX.
2. VERIFY THE KEYPAD CONNECTION.
3. VERIFY THAT THERE IS NO WATER REACHING
ELECTRICAL COMPONENTS UNDER YOUR BATH-
TUB.
(8)