D3 IFTD T SERIES Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} D3 IFTD T SERIES. D3 IFTD T SERIES 12 pages. Touch table 55 inch

Imprimer la page

Getting Started

Button Configuration

1. Power On / Off Function

Press once to power ON and press and hold for more than 3 seconds to power OFF.

1-2. Mode Switching Functions

1) Once powered ON, press the D3 button once to launch the Touch OSD.

2) When the Touch OSD menu appears, choose your desired options.

Click

3. The AC Power cable should be connected

to the AC Inlet here.

2. Screen Rotation Function

Use this to rotate the screen 180 degrees.

Touch Table Height Adjustments

1. Increase Touch Table Height (Up Button)

2. Decrease Touch Table Height (Down Button)

Caution

When adjusting the height of the Touch Table, it is important to operate it safely. Do not leave things on the

surface of the Touch Table or underneath it when adjusting the height. Take a common sense approach to using

this Touch Table. Please consider the safety of those around you.

3. Memory Button 1 (s1)

You can select and save up to three different preprogrammed height settings. Follow these instructions:

1) Choose your desired height.

2) Press the Set (Save) button.

3) Press the S1 (Or S2, S3) Memory button to save the desired height.

4) The selected Memory button is now preprogrammed.

Note:

When adjusting the height to a preprogrammed one, press and hold the desired Memory button (S1, S2, S3) until the

Touch Table has fully reached the required preprogrammed height. The Touch Table height will not adjust automatically

with a single press of the Memory button.

4. Memory Button 2 (s2)

See above.

5. Memory Button 3 (s3)

See above.

6. Set (Save) Button.

Operation

Note : Zero Adjustment

Occasionally the legs may become misaligned.

If they require recalibration follow these steps.

1) Return the table to its lowest setting by pressing the Down button.

2) After it has reached it's minimum height, continue to press the

Down button. The table should automatically recalibrate.