Da-Lite ADVANTAGE ELECTROL Manuel d'instruction - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Da-Lite ADVANTAGE ELECTROL. Da-Lite ADVANTAGE ELECTROL 12 pages. Tensioned large
Également pour Da-Lite ADVANTAGE ELECTROL : Manuel d'instruction (12 pages), Manuel de l'installateur (2 pages), Manuel d'instruction (4 pages), Manuel d'instruction (12 pages), Manuel d'instruction (16 pages)
Imprimer la page
IMPORTANT SAFETY INSTRUCTIONS
When using your video equipment, basic safety precautions should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over,
pulled, or contact hot surfaces.
3. If an extension cord is necessary, a cord with a current
rating at least equal to that of the appliance should be
used. Cords rated for less amperage than the appliance
may overheat.
TOOLS REQUIRED FOR INSTALLATION
#2 Phillips Screwdriver
PRE-INSTALLATION
1. Carefully unpack case from shipping carton.
2. Set aside the Installation Kit. Items inside will be used during
installation.
3. Make sure to recheck measurement of case for proper
installation clearance.
4. Remove any protective foam covering the outside of
the case.
CASE INSTALLATION
1. Hang case and attach to support structure with bolts. See
Suggested Methods of Installation.
2. Tighten bolts until trim flange is flush with ceiling.
NOTE: For proper operation, screen assembly must be level
after installation.
3. Remove 2 screws to open junction box. Install electrical
connections that apply to your unit. Make sure to review the
wiring diagram for proper hook up. Replace junction box
cover and secure with 2 screws.
NOTE: Must be installed in accordance with the
requirements of the Local Building Codes, the Canadian
Electrical Code (CEC), CAN/CSA C22.1 and the National
Electric Code (NEC), NFPA 70.
2
1/2" Open Wrench
or Socket Driver
4. To reduce the risk of electric shock, do not disassemble
this appliance. Contact an authorized service dealer
when repair work is required. Incorrect reassembly can
cause electric shock when the appliance is used
subsequently.
5. The use of an accessory attachment not recommended
by the manufacturer may cause a risk of fire, electric
shock, or injury to persons.
5. For shipping purposes, foam is also inserted between the
roller brackets and endcaps (Figure 1). Remove these foam
blocks from the ends.
6. Remove the hanger brackets from the top of the case using
a 1/2" wrench. Do not discard the hardware; it will be used
during case installation to re-attach the hanger brackets for
mounting.
If your case was ordered in advance of the screen and roller
assembly, your installation is now complete. Continue to
step 4 if your Advantage Electrol was ordered as a complete
unit.
4. Carefully remove paper and tape from roller assembly.
DO NOT use a knife or sharp object to cut tape; you will
damage the screen. Pull orange string.
5. Test installation by running screen up and down a few times.
Be prepared to stop screen should any objects obstruct the
movement of the screen. To prevent damage to the motor,
the standard duty cycle is 1 minute on and 3 minutes off.