SCREEN ADJUSTMENT FOR 120V SCREENS WITHOUT A BUILT-IN LOW VOLTAGE CONTROL
Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly
adjusted at DA-LITE. Should it be necessary to adjust for more or less picture drop (viewing area), proceed in the
following manner:
NOTE: Use a screwdriver or allen wrench to make adjustments.
SETTING THE DOWN LIMIT POSITION
TO REDUCE SCREEN DROP:
Turn the white limit switch screw clockwise to decrease the amount of screen drop. Run the screen down to test
the stop position. If the screen drops too far, raise the screen about one foot and adjust the limit switch again.
Repeat until the desired position is set.
TO INCREASE SCREEN DROP:
Turn the white limit switch screw counterclockwise to increase the amount of screen drop. Run the screen down
to test the stop position. If the screen does not drop enough, raise the screen about one foot and adjust the limit
switch again. Repeat until the desired position is set. Do not adjust for more drop than what was ordered. At least
1-1/2 wraps of fabric must remain on the roller.
SETTING THE UP LIMIT POSITION
▲
CAUTION: Do not allow the slat bar to wrap over the top of the roller when the screen is rolling into the case. The screen could
!
be damaged.
SCREEN TRAVELS INTO CASE TOO FAR:
Turn the black limit switch screw clockwise to decrease the amount of travel. Run the screen up to test the stop
position. If the screen does not stop properly, lower the screen about one foot and turn the limit switch again.
Repeat until the desired position is set.
SCREEN DOES NOT TRAVEL FAR ENOUGH INTO CASE:
Turn the black limit switch screw counterclockwise to increase the amount of up travel. Run the screen up to test
the stop position. If more travel is desired, lower the screen about one foot and adjust the limit switch again.
Repeat until the desired position is set.
COSMOPOLITAN
®
ELECTROL
120V WIRING DIAGRAM
TO JUNCTION BOX, MOUNTED IN
SCREEN CASE, IN WHICH INTERNAL
WIRING TERMINATES IN WHITE,
BLACK AND RED LEADS
DOWN
SIDE VIEW
OF SWITCH
NOTE: A single switch cannot be used to operate more than
®
INSTALLATION
BLACK
ROCKER
SWITCH
WHITE
UP
RED
OFF
BLACK WITH
YELLOW
AC COMMON
AND BOX
AC HOT
120 V. 60 HZ. 2.5 MAX. AMP
THIS SWITCH CANNOT BE USED WITH LVC.
one screen. Contact the factory for further information.
WIRING ENCLOSURE COVER
UP BLACK
LIMIT SWITCH
ADJUSTMENT
AND DOWN
WHITE LIMIT
SWITCH
ADJUSTMENT
OPERATING SWITCH AND
PLATE FURNISHED WITH
SCREEN. (SPDT WITH
CENTER OFF)
3
IN MULTIPLE CONTROL INSTALLATIONS
THIS SWITCH IS REPLACED BY THE LOW
VOLTAGE CONTROL, OPERATED FROM
PUSH BUTTON STATIONS.
FIGURE 3
Imprimer la page