Da-Lite Fast-Fold Manuel d'instruction - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Da-Lite Fast-Fold. Da-Lite Fast-Fold 8 pages. Truss frame
Également pour Da-Lite Fast-Fold : Manuel d'instructions de montage (16 pages), Manuel d'instruction (4 pages)

Imprimer la page

Folding The Picture Surface For Packing

When folding the screen material for packing, observe the following precautions before proceeding:

1. The surface should not be allowed to contact painted,

varnished or plastic finished objects for a prolonged

period of time.

2. Make certain the picture surface is on a clean, flat surface.

Then proceed in the following manner:

Place clean white tissue paper – with no printing – on top of the

picture surface. If tissue is not available, a soft white cloth or

something similar will serve the same purpose. Under no

conditions should newspaper or anything similar be used since

these may damage the screen material.

1. With the viewing side facing up, fold the fabric in half from

top to bottom. Make certain when folding, the surface does

not come in contact with either the black binding, grommets

or snap buttons.

2. If the material on the first fold is more than 3 feet

high, then fold once again, but always place clean tissue

paper between the folds.

3. For large size screens, fold in half again if necessary. Make

certain when folding, the surface does not come in contact

with either the black binding, grommets or snap buttons.

4. After the top to bottom folding procedure is completed, then

fold from left to right and continue folding until the fabric is of

sufficient size to fit into the leatherette case.

NOTE: Keep the screen surface in the envelope provided when it

is not in use. Failure to observe these normal precautions may

cause discoloration of the material.

Cleaning

Da-Mat®, Da-Tex®, High Contrast Da-Tex®, Pearlescent, Cinema

Vision, Dual Vision, Ultra Wide Angle and 3D Virtual Black™

surfaces can be cleaned as follows:

Using a white clean cloth (100% cotton preferred) that is

dampened with clear water, gently wipe the area in one

direction. Do not use a circular motion. Using a dry 100% cotton

cloth, wipe dry after each cleaning session. To clean a stubborn

stain or a sticky surface, use denatured alcohol (methanol or

methyl alcohol) following the same procedure as for water. For

extremely stubborn stains, use V M & P, Naphtha or Super

Naphtha and follow the same procedure as for water.

NOTE: Fast-Fold® screens are shipped with tissue paper packed

between the folds. This keeps the material from sticking to itself

and makes it easier to unfold.