Da-Lite IDEA Panoramic Manuel d'instruction - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Da-Lite IDEA Panoramic. Da-Lite IDEA Panoramic 12 pages.
Également pour Da-Lite IDEA Panoramic : Manuel d'instruction (12 pages), Manuel d'instruction (8 pages)

Imprimer la page

Wall Mounting Instructions for Screens with 24" Marker Tray (continued)

5. Repeat Steps 3-4 to install the (4) remaining L-brackets for the side

panels.

NOTE: At this point, all six L-brackets will be mounted on the wall;

two L-brackets for each panel. Do not proceed if all six-L brackets

are not level with each other on the wall.

Steps 6-7 require at least four people. Place one person on the

far left end of the screen, one person at the left panel seam,

one person at the right panel seam and one person on the far

right end of the screen. More people can be utilized as

needed. When lifting the screen off of the clean work area to

the wall and then onto the wall, it is crucial that the screen

remain coplanar and does not bend at the seams.

CAUTION: Any bend between the three panels at the seams

may damage the screen or result in a permanent gap

between the seams.

6. Using all four people, carefully lift the fully assembled three panel

screen to an upright position and place underneath the mounted

wall and L-brackets. The screen will be parallel to the wall at the

end of this step.

7. Using all four people, carefully and in a smooth motion lift the

screen to hang it on the four installed wall brackets. There is a lip

on the back of the frame that wedges itself into the four wall

brackets once full installed. Ensure that the screen clears the six

L-brackets and that the screen weight is on the four wall brackets,

not the six L-brackets.

8. Center the aluminum tray to the bottom of the center panel

frame and attach with (3) of the provided #8 x 1/2" screws. Insert

screws through the tray into the groove (Figure 4).

9. Tap the bottom of the six L-brackets with the rubber mallet until

they make contact with the frame. Secure the six L-brackets to the

frame with the remaining (12) #8 x 1/2" screws (Figure 4).

#8 X 1/2" Screws

Figure 4

#8 X 1/2" Screws