Da-Lite Motorized Scenic Roller Screen Manuel d'instruction - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Da-Lite Motorized Scenic Roller Screen. Da-Lite Motorized Scenic Roller Screen 8 pages.

Imprimer la page

Installation

Before proceeding with the installation please read the installation and operating instructions thoroughly. Make sure

to recheck measurements of screen and hanger locations before installation. Area must be clear for screen to operate.

With all lid sections removed from shipping container, remove the screws holding the frame to the shipping container

(2 per cross brace). The screen can now be carefully lifted out of the container.

Method A

The frame can be mounted to ceiling with 5/16" diameter

threaded rods. Level frame from front to back and left to right.

Mount from all cross braces (Figure 1).

Suggested Method Of Installation

Method A – Secure To Ceiling

Secure To

Suit

Cross

Brace

Front

Cable

Electrical Installation

Screen motors have been internally wired at Da-Lite. Wiring

designated "external" is completed by installer conforming to

local and national codes. Refer to wiring diagram on next page.

Check for satisfactory condition by operating the screen. Be

prepared to stop screen. Standard Duty Cycle:

1 MIN. 30 SEC. ON / 45 MIN. OFF.

CAUTION! Excessive continuous operation may cause

overheating and motors will shut off.

Let motors cool 10 to 15 minutes and continue test.

ATTENTION! Le fonctionnement continu et excessif peut

provoquer une surchauffe et l'arrêt du moteur. Laissez le

moteur refroidir pendant 10 à 15 minutes et poursuivez le

test.

Check the cables to make sure they are winding on the motor

and roller pulleys properly.

Ceiling

Secure To Suit

5/16" Threaded Rod

(6 Cross Braces)

(Not Furnished)

Back

15"

Safety Switch Trigger

Figure 1

Method B

Hang from a pipe (fly the screen). Level frame from front to

back and left to right. Mount from all cross braces (Figure. 2).

NOTE: Motor pulley must clear pipe. Chains must clear

motor tubes.

Suggested Method Of Installation

Method B – "Flying Pipe"

Ceiling

Cross

Brace

Front

Screen Adjustment

1. With screen in complete unrolled position, examine the

screen surface carefully. If fabric does not hang flat, loosen

the nuts on the eyebolts of the black clamps. Adjust the

wingnuts to pull or relax the fabric as needed. Several clamp

heights may be adjusted depending on the severity of the

hang. After adjustment, tighten the nuts against the

underside of the frame. Caution stage hands and others to

check area before lowering screen. Do not bump screen with

ladders, scenery, etc.

Pipe To Suit

Chain To Suit

(6 Cross Braces)

(Not Furnished)

Eye Bolts For Leveling

(Not Furnished)

Back

Safety Switch

Trigger

Figure 2