Canon Color imageCLASS MF8170c Manuel du réseau - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel du réseau pour {nom_de_la_catégorie} Canon Color imageCLASS MF8170c. Canon Color imageCLASS MF8170c 48 pages. Color laser copier printer scanner fax with network
Également pour Canon Color imageCLASS MF8170c : Instructions d'installation (1 pages), Instructions supplémentaires (2 pages), Manuel d'instructions (8 pages), Manuel d'instructions (8 pages), Manuel de l'interface utilisateur à distance (40 pages), Spécifications (2 pages)

Imprimer la page
Canon Color imageCLASS MF8170c Manuel du réseau

Preparation for Protocol Settings

Before you specify the machine's protocol settings, it is necessary to specify the
machine's IP address to enable communication between the machine and your
computers. You can use any of the following to specify the settings. Specify the
settings using the easiest method.
•
The machine's operation panel
•
NetSpot Device Installer (Canon utility software included in the User Software CD)
•
The ARP/PING commands
IMPORTANT
•
In the following operations, the machine's MAC address is necessary. To check the MAC
address from the machine's operation panel, print a USER DATA LIST. (See Chapter 6,
"Reports and Lists," in the Facsimile Guide.)
•
Before you perform the following operations in this section, check that the machine is ON
and connected to the network.
•
If you are using ARP/PING commands, the following steps directly allocate the IP
address to the machine. For this machine, in addition to direct allocation of the IP
address to the machine, you can use DHCP, BOOTP, or RARP to specify the IP address.
When the machine is started or reset, it checks whether DHCP, BOOTP, or RARP is
being used, and then allocates an IP address using the first available setting method.
Because the machine's IP address is automatically allocated at this time, it is not
necessary for you to perform the following operations in this section. However if you are
reallocating the IP address, or if DHCP, BOOTP, or RARP is not used, perform the
following operations.
Preparation for Protocol Settings
2
2-3