American Standard T010.740 Manuel d'instructions d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} American Standard T010.740. American Standard T010.740 12 pages. Central thermostat with volume control trim kit
Imprimer la page
1
1
TRIM INSTALLATION
Remove PLASTER GUARD (1) if attached.
Push CAPS (2 & 2a) as shown onto CONTROL
VALVES (3).
Push ESCUTCHEON HOLDER (4) with lightly greased
O-RING SEALS (5) over CAPS (2, 2a).
Attach the FIXATION PLATE (7) to the ESCUTCHEON
HOLDER (4) with the two SCREWS (6) provided.
Push ESCUTCHEON (8) flush against finished wall.
1 2
INSTALL HANDLES
Attach HANDLE ADAPTER (1) to KNOB MOUNT (2) with SCREW (3).
Align HANDLE (4) as shown and push onto KNOB MOUNT (2).
Tighten SET SCREW (5) with HEX WRENCH (6) supplied with trim kit.
Install HANDLE SCREW (7) into VALVE STEM (8) and tighten.
Align HANDLE (9) as shown and push onto HANDLE SCREW (7).
Tighten SET SCREW (5a) with HEX WRENCH (6) su pplied with trim kit.
TRANSPOSED SUPPLY PIPING
3
OR BACK TO BACK INSTALLATION
Should the hot and cold water supply pipes have been transposed making
adjustment impossible, proceed as follows:
Shut off water supply.
Remove handle and rim.
Remove check stops and re-install them transposed.
Important note: RED CHECK STOP is now on the right of the mixer body and the BLUE
CHECK STOP is now on the left.
Turn the water supply back on and perform the temperature adjustment in step 4.
Assemble HANDLES and TRIM.
.
(Reverse steps 1 and 2)
2
4
3
2a
5
7
2
1
3
CHECK STOP
(RED TO BLUE)
1
6
8
8
7
9
5a
4
5
6
CHECK STOP
(BLUE TO RED)
M 9 6 8 0 2 2