American Standard SELECTRONIC 2506.1X5 Manuel d'instructions d'installation - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} American Standard SELECTRONIC 2506.1X5. American Standard SELECTRONIC 2506.1X5 10 pages. Moments proximity faucets
Imprimer la page
MAINTENANCE
HAND WASH SENSOR OPERATION;
A
Fig. 1
When the Sensor detects a user, the water immediately
starts to flow. Water flow will stop 2 seconds after user is
out of sensor range. The off delay allows the user to
comfortably move his hands without the flow cycling on
and off. As a precaution, a safety timer will turn off the
water, after the sensor has been blocked for 59 seconds.
The water will stay off until the blockage is removed from
the detection zone.
Detection Zone: 2" - 10" (50mm - 250mm)
Default: Set at Factory 6" (150mm)
B
CHANGE SENSOR RANGE;
(Factory set at 6") Fig. 2, 2a
1. Remove cover from ENCLOSURE. Disconnect
Power Supply (1), then reconnect. Fig. 2.
2. While the SENSOR CONTROL LED (2) is blinking
slowly, place your hand 1 - 2 in. (30-50mm) in front
of the sensor. Fig. 2a.
3. When the LED stops blinking and stays "ON", move
your hand to the desired position and hold in place
until the LED begins to blink again. Fig. 2a.
4. Once the SENSOR CONTROL LED (2) begins to
blink again, remove your hand from the detection
zone. When the flashing stops, the detection
distance is set.
5. Replace ENCLOSURE COVERS (2). Tighten cover
screws firmly.
CLEAN FILTER ASSEMBLY; Fig. 3
C
CAUTION
Before opening ENCLOSURE disconnect AC power supply.
1. Remove ENCLOSURE COVER.
2. Close SUPPLY STOP (13) with 4mm Hex wrench.
Note: Activate sensor to keep water flowing out of
faucet while shutting off.
3. Unthread FILTER ASSEMBLY (6) using a 7/16" socket.
4. Pull out the FILTER ASSEMBLY (6), remove and clean
white debris cup and filter screen.
5. Install the FILTER ASSEMBLY (6) back in its place and
tighten with a 7/16" socket.
Caution: Do not over tighten.
6. Open SUPPLY STOP (13) with 4mm Hex wrench.
7. Replace ENCLOSURE COVER. Tighten cover
screws firmly.
Fig. 1
Fig. 2
1
Fig. 2a
1" - 2" (30mm - 50mm
2
BLINKING LED
Fig. 3
13
4mm HEX WRENCH
7
Fig. 2a
UP TO 10"
(250mm)
2
BLINKING LED
7/16" SOCKET
6
WHITE
DEBRIS
CUP
FILTER
SCREEN