EKKO EA15B Manuel - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} EKKO EA15B. EKKO EA15B 9 pages. Semi electric stacker
Également pour EKKO EA15B : Spécifications (9 pages), Manuel d'entretien (14 pages)
Imprimer la page
Plug the charger into any 110V outlet, then plug the charger into the unit of the
recharging socket. It will automatically stop charging when charge is complete.
5. Troubles shooting
No
Trouble
The forks can't lift to the max.
1
height.
2
The forks cannot lift at all.
3
Does not power up.
4
The
forks
descended.
5
Leaks
The fork descends by itself
6
7
Battery cannot be charged
Note: Without authorization or training, it is strictly prohibited to repair!
-Low on hydraulic fluid
-No hydraulic fluid.
-The tank or fluid has impurities.
-The emergency switch is pressed
down
-The battery is too low.
-The connectors of electrical
wiring is loose.
-The contact of DC motor is bad.
-The piston rod or mast is
deformed resulting from partial
loading slanting to one side or
over-loading.
cannot
be
-The fork was kept in the high
position for long time with
piston rod bared to arise in
rusting and jamming of the rod.
-The release valve of pump is not
opened.
-Seals are worn or damaged.
-The impurities in the fluid
caused the release valve not
properly seal shut.
-Sealing parts worn or damaged.
-The release valve is damaged.
-Battery is bad.
-The charging plug is loose.
Cause
-Add hydraulic fluid.
-Add hydraulic fluid
-Change fluid
-Pull emergency switch up.
-Charge it.
-Tighten the bolts.
-Replace with new one.
- Replace with new one.
-Keeping the fork in the lowest
-Check it, if damaged, replace
-Replace with the new one.
-Replace with new oil.
-Replace with the new one.
-Replace with the new one.
- Replace with the new one.
- Tighten the clamps or bolts
- 5 -
Solution
position if not using and pay
more attention to lubricate the
rod.
with new one.