American Time Global Series Démarrage rapide Manuel d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Démarrage rapide Manuel d'installation pour {nom_de_la_catégorie} American Time Global Series. American Time Global Series 2 pages. Power over ethernet (poe) digital clocks

Imprimer la page
QUICK START INSTALLATION GUIDE
4
Set up the Clock
1.
To power up the clock, connect a CAT 5 or higher Ethernet patch cable
switch (Fig. 1) or single injector (Fig. 2) and to the rear panel. The time should display in
20-40 seconds.
—PoE Switch (Fig.1) - Check with network administrator for infrastructure needs. This part
is not supplied by American Time.
—PoE Injector (TMA200) (Fig. 2) - This is an optional power source that may be
purchased from American Time.
Note: When a DHCP network is not present at initial start up, the PoE clock will default
to a random Static IP in the range of 169.254.1.0 to 169.254.254.255.
For more details, reference the Power over Ethernet (PoE) Clock Installation & Operation
Manual by navigating to https://www.american-time.com/support/product-documentation.
Search "PoE" and click on "PoE Analog and Global Series Digital Manual" to download.
Ethernet
Gigabit Switch
1
3
5
Act
LED
Mode
FDx
Power
Fault
Spd
Locator
Reset
Clear
2
4
6
B
B
A
C
A
TMA200
A=PoE connection
(CAT 5 or higher Ethernet patch cable)
B=Keyhole hanger C=Relay
(A)
to a PoE
10/100/1000 Base-T Ports (1-24)
7
9
11
13
15
17
19
21
23
8
10
12
14
16
18
20
22
24
PoE Switch
Fig. 1
A
Fig. 2
POWER OVER ETHERNET DIGITAL CLOCKS
5
Adjustments via Network Clock Connect
1.
Download Network Clock Connect from:
https://www.american-time.com/support/product-documentation. Select "firmware"
and click Search Now. Click on Network Clock Connect from the list. The software
will automatically download.
2.
Install Network Clock Connect application – Password = clock4u (default)
3.
Network Clock Connect will allow you to configure:
• Network address settings
• Time Synchronization settings
• Daylight Saving Time settings
• Schedules (Buzzer clocks) - maximum of 100 scheduled events
For more details, reference the Power over Ethernet (PoE) Clock Installation and
Operation Manual.
6
Hang your clocks
1.
Mount the included bracket to a gang box or to the wall, using at least two of the
holes on the bracket.
2.
Insert the spring legs on the bracket in the channel at the rear bottom of the clock.
3.
Push the clock up to compress the springs, then push the top of the clock towards the
wall to insert the bracket studs in the keyhole slots on the clock backplate.
3.
Release the clock. The bracket studs should slide into the upper portion of the keyhole
slots to retain the clock. If the studs have not seated, wiggle the clock gently until the
studs align with the slots and slide into place.
Fig. 3