Dongcheng DJX03-255 Manuel d'utilisation - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Dongcheng DJX03-255. Dongcheng DJX03-255 14 pages. Electric mitre saw
Imprimer la page
17. Do not force the power tool. Use the correct power tool for your
application. The correct power tool will do the job better and safer at the rate
for which it was designed.
18. Do not use tool if switch does not turn it on or off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
19. Disconnect the plug from the power source and/or the battery pack
from the power tool before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
20. Store idle power tools out of the reach of children and do not allow
persons unfamiliar with the power tool or these instructions to operate
the power tool. Power tools are dangerous in the hands of untrained users.
21. Maintain power tools. Check for misalignment or binding of moving
parts, breakage of parts and any other condition that may affect the
power tool's operation. If damaged, have the power tool repaired before
use. Many accidents are caused by poorly maintained power tools.
22. Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
23. Use the power tool, accessories and tool bits etc. in accordance with
these instructions, taking into account the working conditions and the
work to be performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
Service
24. Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power
tool is maintained.
VOLTAGE WARNING:
Before connecting the machine to a power source (receptacle, outlet, etc.), be
sure the voltage supplied is the same as that specified on the nameplate of the
machine. A power source with voltage greater than that specified for the machine
can result in SERIOUS INJURY to the user, as well as damage to the machine. If
in doubt, DO NOT PLUG IN THE MACHINE. Using a power source with voltage
-3-
less than nameplate rating is harmful to the motor.
SPECIFICATIONS
Rated Power Input
No-Load Speed
Blade Diameter
Hole Diameter of Blade
Miter Angle
Max. Cutting
Bevel Angle
Capacity
0°
(H×W)
45° (Left)
Net Weight
※Due to the continuing program of research and development, the specifications
herein are subject to change without prior notice.
ADDITIONAL SAFETY RULES
1. Always wear eye protection to avoid injuries to eyes cased by the flying out
sawdust.
2. Do not operate this tool without guards in place. Check blade guard for proper
closing before each use. Do not operate miter saw if blade guard does not move
freely and close instantly. Never clamp or tie the blade guard at the open position.
3. Do not use the tool in the presence of flammable liquids or gases.
4. Check the blade carefully for cracks or damage before operation. Replace cracked
or damaged blade immediately. Gum and wood pitch hardened on blades slows
saw and increases potential for kickback. Keep blade clean by first removing it
from tool, and then cleaning it with gum and pitch remover, hot water or kerosene.
Never use gasoline to clean blade.
5.
Use only flanges specified for this tool.
1650 W
6000 r/min
Ø255mm
Ø25.4 mm
45°
0°
(Left and Right)
60mm×130mm
60mm×93mm
45mm×130mm
45mm×93mm
12.0 Kg
-4-