Astonica 50100244 Manuel d'instruction - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Astonica 50100244. Astonica 50100244 2 pages. La trec sling motion chair

Imprimer la page
PARTS LIST
PART #
A
Chair Seat
B
Chair Frame
C
Back Cross Bar
D
Bolt, Long
E
Bolt, Short
F
Washer
G
Bolt Cap, Plastic
A
B
C
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
Tools Required (Not Included)
DESCRIPTION
D
E
F
G
Completed Assembly
QUANTITY
1
1. (SEE FIGURE 1) Lay chair seat (A) face
1
down on a non-abrasive surface to
prevent scratching frame.
1
4
2
6
2
2. (SEE FIGURE 2) Lay chair frame (B) on top
of chair seat.
CAUTION: Do not over tighten fasteners
3. (SEE FIGURE 3) Align front screws (D),
and washers (F) tighten slightly.
4. Align rear screws (D), washers (F)
and tighten slightly.
NOTE: Adjust chair frame (B) to reduce
pressure on bolts.
5. (SEE FIGURE 4) Attach back cross bar
to chair frame using short bolts (E)
and washers (F).
6. Tighten all bolts, alternate from one bolt
to the next turning each bolt approximately
five times before moving to the next bolt.
7. Lift assembled chair upright and ensure
all bolts are secure.
8. Install bolt cap (G) over bolts (E).
ASSEMBLY INSTRUCTIONS
Figure 1
Figure 2
Figure 3
Figure 4
A
B
B
D, F
D, F
E, F, G
C