Astonica 40201030 Instructions d'assemblage - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions d'assemblage pour {nom_de_la_catégorie} Astonica 40201030. Astonica 40201030 3 pages. 3-tier wooden tub fountain

Imprimer la page

PARTS & HARDWARE LIST

PART #

DESCRIPTION

Small Washtub

Medium Washtub

Large Washtub

Pump

6mm Nuts

Clear Hose

Carefully remove the contents from the package. If any parts are missing do

not attempt to use the product until they have been obtained and correctly

installed.

IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,

DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT

1-888-424-3354.

Caution: Do not over tighten fasteners.

WARNING! Read and understand all safety and operating instructions.Failure to follow all

instructions listed as well as good common sense practices may result in electric shock,

property damage, fire, and/or serious personal injury.

ELECTRICAL SAFETY INSTRUCTIONS

Grounding instructions

This fountain must be plugged into a 3-wire, 3-prong outlet that is properly working and has

been installed and grounded in accordance with all local, state or Federal codes and ordinances.

DANGER: Failure to connect this tool to a properly grounded outlet can result in DAMAGE, FIRE,

ELECTRIC SHOCK or FATAL INJURY. Consult a qualified electrician if you are in doubt as to whether

the outlet is properly grounded. Do not modify the plug provided with the product - if it will not fit

the outlet; have a proper outlet installed by a qualified electrician. Do not use any type of adapter

with this product.

QUANTITY

Figure 1

1. Connect the clear hose (F) with the top of the pump (D). Figure 1.

2. Place the pump (D) and clear hose (F) assembly into the bottom of the large washtub (C),

ensure that it is aligned with and pulled through the large predrilled hole in the platform on top

of the large washtub (C).

3. Align the pre-installed studs on the bottom of the medium washtub (B) with the pre-drilled holes

on the washtub platform on the large washtub (C). Secure with (2) with 6mm nuts (E).

4. Put the clear hose (F) through the predrilled hole in the bottom of the medium washtub

(B). Align the pre-installed studs on the bottom of the small washtub (A) with the pre-drilled

holes on the washtub platform on the Medium washtub (B). Connect the clear hose (F) on the

installed hose connector on the bottom of the small washtub (A). Secure the small washtub (A)

with (2) 6mm nuts (E).

5. Do not plug in pump before filling container with water. Doing so may damage pump.

6. Use distilled water, if possible to fill container.

7. To adjust speed of water flow: unplug pump, move switch on pump (E) toward "+" positive to

increase water flow, or "-" to decrease water flow.

8. Check water level periodically, add water if necessary.

9. If water is not flowing, check pump (J) or fountain assembly (D), (E), or (C) for clogs. Pump may

build up calcium after a long period of time and stop running when tap water is used. Any

calcium remover can be used to clean pump.

ASSEMBLY INSTRUCTIONS